Exam 76: Driveline Diagnosis and Service

The inner bearing race is supported when the bearing is pressed onto the axle.

Which of the following statements is LEAST-Likely true?

Axles are supported on the outside end by the differential side gears.

When adjusting a differential, a(n) ____________________ is taken off of the ring gear teeth using colored paste painted onto the teeth.

All of the following statements are true EXCEPT:

While having a discussion, Technician A says that a good pattern will tend to be toward the toe of the tooth when tested under light load conditions. Technician B says that under heavier load a more complete pattern can be read across the gear tooth. Who is correct?

Full-floating axles are found on passenger vehicles.

A problem with driveshaft angles can cause ____________________, which often happens on the ends of the trunnions.

Briefly describe four things you should look for when inspecting a drive shaft?

All of the following statements are true EXCEPT:

The ____________________ side of the gear teeth is convex.

Noise from a worn U-joint can include squeaking, clunking, knocking, or grinding sounds.

While having a discussion, Technician A says that noise during acceleration points to heavy heel contact. Technician B says that noise does not usually occur during acceleration. Who is correct?

A(n) ____________________ runs through the center of the tooth from heel to toe.

A vise can be broken if excessive force is used when the jaws are far apart.

The term MOST-Likely used when terms analyzing gear tooth patterns is:

What could cause damage to differential gears?

The ____ of a gear tooth is the outer end.

____________________ measures how far the pinion gear extends into the differential housing.

How would you remove a third member from a banjo housing?