Exam 72: Manual Transmission Diagnosis and Repair

arrow
  • Select Tags
search iconSearch Question
  • Select Tags

After all of the gears are assembled onto the mainshaft, gear clearance is checked at each of the gears. Normal clearance is ____________________ to 0.005".

Free
(Short Answer)
4.8/5
(85)
Correct Answer:
Verified

0.002",.002"

When ordering parts from a dealer or parts store, you do not need to identify the transmission.

Free
(True/False)
4.9/5
(68)
Correct Answer:
Verified

False

While having a discussion, Technician A says that you should never use the transmission bolts to draw the transmission into the clutch. Technician B says that the transmission should slide all the way in by hand. Who is correct?

Free
(Multiple Choice)
4.7/5
(81)
Correct Answer:
Verified

C

The part that can MOST-Likely be used during transmission assembly to make reinstallation of the countershaft much easier is:

(Multiple Choice)
4.7/5
(79)

What steps would you take to gain easier access to the nuts that hold a shifter handle in place on a rear-wheel-drive vehicle?

(Short Answer)
4.9/5
(74)

You should always use a punch to mark a synchro sleeve.

(True/False)
4.9/5
(89)

The lubricant that will MOST-Likely leave no strings of grease when you put a small amount between two fingers and then spread them apart is:

(Multiple Choice)
4.8/5
(76)

Worn linkage, driving with a defective clutch, or wear resulting from extra-high mileage can cause transmission problems.

(True/False)
4.9/5
(72)

Transmission failure can result from abuse or shocks to the transmission.

(True/False)
5.0/5
(91)

All of the following statements are true EXCEPT:

(Multiple Choice)
4.8/5
(80)

All of the following statements are true EXCEPT:

(Multiple Choice)
4.9/5
(98)

Why do you think the drive gear for the VSS or speedometer does not need to be replaced often?

(Short Answer)
4.8/5
(82)

Before attempting to install the transmission, be sure that the ____________________ is seated correctly on its pivot.

(Short Answer)
4.7/5
(93)

____________________ can occur when too high a gear range (overdrive) is selected at speeds below approximately 50 miles per hour.

(Short Answer)
4.9/5
(84)

Why should you oil rubber seals and O-rings during installation?

(Short Answer)
4.8/5
(88)

The ____________________ at the ends of the countergear control the amount of end clearance.

(Short Answer)
4.9/5
(71)

How would you check lubricant level?

(Short Answer)
4.8/5
(74)

What are some of the steps you should take before removing the transmission from a vehicle?

(Short Answer)
4.7/5
(80)

A short shaft can be used to keep the needle bearings in the countershaft. This shaft, called a(n) ____________________, is slightly shorter than the case.

(Short Answer)
4.9/5
(67)

Which of the following is LEAST-Likely a symptom a transmission could have?

(Multiple Choice)
4.8/5
(86)
Showing 1 - 20 of 25
close modal

Filters

  • Essay(0)
  • Multiple Choice(0)
  • Short Answer(0)
  • True False(0)
  • Matching(0)