Exam 11: Lifting Equipment and Air Compressors

Each output line from the air feed system is called a(n) ____________________.

Most receivers for compressors larger than 5 HP are vertical.

To bolt a surface mount lift, the floor must have at least ____ of solid concrete.

An advantage to frame-contact, axle engaging, or pad lifts is that the wheels hang free, which makes it easier to perform tire, brake, and suspension work.

The MOST-Likely equipment to have adapters at the end of adjustable lift arms is the:

Two-stage compressors are used when pressures below 100 psi are required.

Name four safety precautions you should bear in mind when operating a lift?

Drive-through lifts are more open in the center to allow easier access to the underside of the vehicle.

The organization that is MOST-Likely to promote the safe design, construction, installation, operation, maintenance, and repair of automotive lifts is:

All of the following are components of a wheels-free air-hydraulic jack EXCEPT:

A(n) ____________________ lift is one in which all four of the vehicle's wheels are supported.

Lift pads should face either toward each other or away from each other to form a "V"or an "A."

Which of the following is LEAST-Likely to leak oil into the ground?

What steps should you take to properly maintain the air compressor?

What are the advantages of wheel-contact lifts?

Where would you install an air compressor?

An air compressor is operating at its maximum practical capacity when it runs for 7 out of every 10 minutes. This is referred to as a 70% ____________________.

Air compressor ____________________ is dependent on the number of tools that will be in use in the shop at one time and their air requirements.

While discussing center of gravity, Technician A says that on front-wheel-drive (FWD) cars, the center of gravity is usually slightly in front of the driver's seat, beneath the steering wheel. Technician B says that the center of gravity is usually below the driver's seat. Who is correct?

While having a discussion about lifts, Technician A says that a fully hydraulic lift has a self-contained air/oil reservoir. Technician B says that it is the semi-hydraulic lift that has a self-contained air/oil reservoir. Who is correct?