Question 1

Dirt is the number one cause of engine wear.

Accepted Answer

A) True 
 B)False  True

Question 2

When conducting a visual inspection of the electrical system, what are some of the obvious problems that you should look out for?

Accepted Answer

Check for bare or burned wires that might be able to bridge a circuit to ground. This would probably result in a blown fuse. But it could also cause a spark, resulting in an explosion of fuel or the battery. Inspect the connections on the AC generator and ignition system wiring. Look for loose or corroded connections, which can cause annoying intermittent electrical problems.

Question 3

Which of the following is LEAST-Likely to alert the driver that the brake pads are worn?

Accepted Answer

A)  The fluid level. 
B)  The audible sensor system. 
C)  An electronic sensor that causes the pedal to pulsate when the pads become too worn. 
D)  An electronic sensor that causes a dash light to illuminate. 
A)  The fluid level. 
B)  The audible sensor system. 
C)  An electronic sensor that causes the pedal to pulsate when the pads become too worn. 
D)  An electronic sensor that causes a dash light to illuminate. A

Question 4

What precautions should you take when checking the ATF?

Accepted Answer

Precautions should you take when checkin

Question 5

____________________ are designed to control the initial movement and subsequent oscillations of the spring during jounce (downward movement of the vehicle) and rebound (movement of the vehicle back up).

Accepted Answer

Shock abso

Question 6

While having a discussion, Technician A says that accidental contamination of the brake hydraulic system with oil can cause serious damage to the rubber parts in some brake systems. Technician B says that accidental contamination with transmission fluid is what can cause this damage. Who is correct?

Accepted Answer

A)  A only 
B)  B only 
C)  Both A and B 
D)  Neither A nor B 
A)  A only 
B)  B only 
C)  Both A and B 
D)  Neither A nor B

Question 7

Battery ____________________ is sulfuric acid and water.

Accepted Answer

The answer of Battery ____________________ is sulfuric acid and water....

Question 8

The radiator ____________________ increases the pressure on the coolant so that its boiling point will be higher than normal.

Accepted Answer

The answer of The radiator ____________________ increases the pressure on...

Question 9

A yellow/orange instrument panel warning light is a(n) ____________________.

Accepted Answer

The answer of A yellow/orange instrument panel warning light is...

Question 10

Fluid level is checked with the engine on.

Accepted Answer

A) True 
 B)False

Question 11

The strength of coolant concentration can be checked with a _____  or coolant test strips.

Accepted Answer

A)  pressure valve 
B)  voltmeter 
C)  pressure test 
D)  refractometer 
A)  pressure valve 
B)  voltmeter 
C)  pressure test 
D)  refractometer

Question 12

The additive that will MOST-Likely neutralize battery acid is:

Accepted Answer

A)  brake fluid 
B)  baking soda 
C)  water 
D)  salt 
A)  brake fluid 
B)  baking soda 
C)  water 
D)  salt

Question 13

All of the following are components of the radiator cap EXCEPT:

Accepted Answer

A)  pressure relief valve spring 
B)  rubber blade 
C)  upper sealing surfaces 
D)  vacuum valve 
A)  pressure relief valve spring 
B)  rubber blade 
C)  upper sealing surfaces 
D)  vacuum valve

Question 14

While discussing brake pedals, Technician A says that prior to taking a test drive to check out a complaint involving the brakes, you should check the master cylinder fluid level, but you don't need to check the brake pedal height prior to the test drive. Technician B says that you should check both the master cylinder fluid level and the brake pedal height . Who is correct?

Accepted Answer

A)  A only 
B)  B only 
C)  Both A and B 
D)  Neither A nor B 
A)  A only 
B)  B only 
C)  Both A and B 
D)  Neither A nor B

Question 15

All of the following are battery components EXCEPT:

Accepted Answer

A)  electrolyte fill holes 
B)  holddown 
C)  overflow hose 
D)  cable connections 
A)  electrolyte fill holes 
B)  holddown 
C)  overflow hose 
D)  cable connections

Question 16

Briefly describe the process involved in conducting a cursory check of shock absorbers.

Accepted Answer

First, check to see that the vehicle sit

Question 17

Drum brakes should always be adjusted before attempting to adjust the parking brake .

Accepted Answer

A) True 
 B)False

Question 18

A complete brake inspection is usually included in a lube service.

Accepted Answer

A) True 
 B)False

Question 19

Which of the following is LEAST-Likely a component of the windshield washer reservoir system?

Accepted Answer

A)  Nozzle 
B)  Hose 
C)  Pump 
D)  Socket 
A)  Nozzle 
B)  Hose 
C)  Pump 
D)  Socket

Question 20

The brake system is required by law to include a parking brake, sometimes called emergency brake , that operates independently of the service brakes .

Accepted Answer

A) True 
 B)False

Exam 13: Underhood and Body Inspection Car on Ground

Dirt is the number one cause of engine wear.

When conducting a visual inspection of the electrical system, what are some of the obvious problems that you should look out for?

Which of the following is LEAST-Likely to alert the driver that the brake pads are worn?

What precautions should you take when checking the ATF?

____________________ are designed to control the initial movement and subsequent oscillations of the spring during jounce (downward movement of the vehicle) and rebound (movement of the vehicle back up).

Battery ____________________ is sulfuric acid and water.

The radiator ____________________ increases the pressure on the coolant so that its boiling point will be higher than normal.

A yellow/orange instrument panel warning light is a(n) ____________________.

Fluid level is checked with the engine on.

The strength of coolant concentration can be checked with a _____ or coolant test strips.

The additive that will MOST-Likely neutralize battery acid is:

All of the following are components of the radiator cap EXCEPT:

All of the following are battery components EXCEPT:

Briefly describe the process involved in conducting a cursory check of shock absorbers.

Drum brakes should always be adjusted before attempting to adjust the parking brake .

A complete brake inspection is usually included in a lube service.

Which of the following is LEAST-Likely a component of the windshield washer reservoir system?

The brake system is required by law to include a parking brake, sometimes called emergency brake , that operates independently of the service brakes .

Introduction to the Automobile

Automotive Careers and Technician Certification

Shop Safety

Shop Management, Service Records, and Parts

Locating Service Information and Specifications

Measuring Tools and Systems

Hardware, Fasteners, Drills, and Thread Repair

Shop Tools

General Shop Equipment

Cleaning Equipment and Methods

Lifting Equipment and Air Compressors

Engine Lubrication

Undercar Inspection and Service

Introduction to the Engine

Engine Classifications and Advanced Transportation Technologies

Engine Size and Measurements

Engine Upper End

Engine Lower End and Lubrication System Theory

Cooling System Theory

Cooling System Service

Automotive Belts

Automotive Hoses

Automotive Plumbing: Tubing and Pipe

Basic Electrical System Theory and Repairs

Battery Fundamentals

Battery Service

Starting System Fundamentals

Starting System Service

Charging System Fundamentals

Charging System Service

Lighting and Wiring Fundamentals

Lighting and Wiring Service

Safety, Security, Comfort Systems, and Electrical Accessories

Heating and Air Conditioning Fundamentals

Heating and Air Conditioning Service

Ignition System Fundamentals

Ignition System Service

Fuels and Alternative Fuels

Fuel System Fundamentals

Fuel System Service

Intake and Exhaust Systems, Turbochargers and Superchargers

Emission Control System Fundamentals

Emission Control System Service

Electronics and Computer Systems Fundamentals

Electronics and Computer Systems Service

Advanced Emissions and On-Board Diagnostics Odb

Diagnosing Engine Performance Problems

Diagnosing Engine Mechanical Problems

Engine Removal and Disassembly

Engine Sealing, Gaskets, Fastener Torque

Engine Diagnosis and Service: Cylinder Head and Valvetrain

Engine Diagnosis and Service: Block, Crankshaft, Bearings, and Lubrication System

Engine Diagnosis and Service: Piston, Piston Rings, Connecting Rod, Engine Balancing

Ordering Parts, Short and Long Blocks, Engine Assembly

Engine Installation, Break In, and In-Chassis Repairs

Brake Fundamentals

Brakes Service

Anti-Lock Brakes Traction and Stability Control

Bearings, Seals, and Greases

Tire and Wheel Theory

Tire and Wheel Service