Exam 10: Power Tools and Shop Equipment

Technician A changes air compressor oil as part of routine maintenance. Technician B purges water out of air compressor tanks as part of routine maintenance. Which technician is correct?

Technician A says that face shields should always be worn when using a bench grinder. Technician B says that face shields are not required if the bench grinder has built-in shields. Which technician is correct?

When using an engine stand ________.

When mounting an engine to an engine stand, what grade bolt should be used?

After using a vise ________.

Two technicians are discussing the use of a typical bench/pedestal mounted grinder. Technician A says that a wire brush wheel can be used to clean threads. Technician B says that the grinding stone can be used to clean threads. Which technician is correct?

Proper care of shop equipment includes ________.

The bearings of shop equipment ________.

Which air impact drive size is the most commonly used?

Engine stands ________.

What can be used to cover the jaws of a vise to help protect the object being held?

When removing a bearing and race from a component ________.

What type of socket should be used with an air impact wrench?

Technician A says that air-operated grease guns are more expensive than battery operated grease guns.Technician B says that battery operated grease guns also require a supply of compressed air. Which technician is correct?

Identify this tool.

Technician A says that incandescent lights may be used when working around gasoline. Technician B says that florescent lights should be used when working around gasoline. Which technician is correct?

What type light may be used in more difficult to access areas?

Using compressed air and a blow gun, what is the maximum allowable air pressure?

A hydraulic press is being used to separate a bearing from a shaft. What should be used to cover the bearing during the pressing operation?

Engines are mounted to engine stands ________.