Exam 130: Automatic Transmissiontransaxle Unit Repair

Clutch pack clearance may be adjusted by all of the following EXCEPT ________.

Clutch pack clearance can be changed, if not correct, by using a selective ________.

Technician A says extra care should be taken when removing and installing the torque converter assembly onto the input shaft, to avoid damaging seals. Technician B says that the transmission oil cooler should be flushed whenever metal particles are found during transmission overhaul. Which technician is correct?

When assembling the pump, what is the alignment band used for?

How much transmission fluid should flow through the cooler?

Why should red assembly lube be avoided?

What part must be replaced if dropped?

What is the correct tool for measuring input shaft and output shaft endplay?

Clutch plate travel can be checked with ________.

All of these may be repaired with the transmission in the vehicle EXCEPT ________.

The VIN is usually not needed when ordering transmission parts.

Steel discs should be ________ before being installed.

Technician A says that all friction and steel plates in a clutch pack should be replaced during an overhaul. Technician B says that the automatic transmission fluid cooler should always be flushed when a unit is rebuilt or replaced. Which technician is correct?

Technician A says that the torque converter should be separated from the flex (drive)when replacing the frictions and steels in a clutch pack. Which technician is correct?

Technician A says that the sharp edges of spool valves should be rounded using 400 grit sandpaper. Technician B says that all valve body parts should be cleaned and then dried using low-pressure, filtered compressed air. Which technician is correct?

The torque converter is normally reused when a transmission is rebuilt.

Air pressure checking is used to test ________.

Technician A says all gaskets should be discarded during teardown to keep the work area clean. Technician B says to keep the old valve body gaskets intact to make sure the replacement is a perfect match. Which technician is correct?

Friction discs should be ________ before being installed.

Slide hammers or a special tool are used to remove what component?