Exam 12: Measuring Systems and Tools

Which of these is the best tool to measure cylinder bore taper and out of round?

Which tool is best to measure valve lift?

For measuring a journal for out-of-round, measurements should be taken every ________ degrees around the journal

The best tool to measure clearance between two components is ________.

A micrometer can be used to measure to an accuracy of ________.

To directly measure the diameter of a valve guide in a cylinder head, use a micrometer and a ________.

Which tool is best to measure linear distance?

What is the reading on this inch micrometer?

What is the reading on this dial caliper?

Which of these objects have a mass of approximately one gram?

To check a crankshaft journal for taper, the journal should be measured in at least how many locations?

Which metric unit of measure is used for volume measurement?

Which tool is necessary to measure flatness of engine components?

To read a dial caliper, ________ the reading on the dial to the reading on the blade.

A telescopic gauge can be used to measure a cylinder bore if what other measuring device is used to measure the telescopic gauge?

A telescopic gauge is used with what other measurement tool?

Which of the following cannot be measured using a feeler gauge?

The threaded movable part that rotates on a micrometer is called the ________.

Which tool is best to measure valve guide diameter?

A telescopic gauge can be used to measure ________.