Exam 27: Ford 6r60 Zf6hp26

A vehicle comes in with a 6R60 transmission with a burned overdrive clutch. Tech A states the problem could be a bad shift solenoid "E." Tech B states the problem could be a bad shift solenoid "C." Who is correct?

Technician A says that the 6R60 transmission has six forward gears and one reverse. Technician B says that six multidisc clutches are used in this transmission. Who is correct?

All of the following solenoids receive a small amount of current from the PCM all of the time except:

Technician A says that all seven shift solenoids are variable force solenoids. Technician B says that all seven shift solenoids are on/off type solenoids. Who is correct?

A vehicle with a 6R60 transmission is towed to the shop with the transmission slipping in forward gears. Tech A states the problem could be a bad direct clutch. Tech B states that the problem could be a bad forward clutch. Who is correct?

How many planetary gears does the Ford 6R60 transmission contain?

Tech A states that on a 6R60 transmission the range sensor is a potentiometer that sends a voltage signal back to the PCM. Tech B states that the range sensor uses pressure switches to indicate gear selection. Who is correct?

Technician A says that the 6R60 transmission has a short dipstick underneath the fill plug. Technician B says that the transmission fluid level of 6R60 transmission can only be checked with a scan tool. Who is correct?

Tech A states that the transmission range sensor of a 6R60 transmission is a traditional switch. Tech B states that the transmission range sensor is a Hall Effect sensor. Who is correct?

For how long should all frictions be soaked in the specified automatic transmission fluid before being installed into the transmission?

The direct clutch assembly on a Ford 6R60 is being discussed. Technician A says that new seals should be installed on the direct clutch piston and the balance piston. Technician B says that transmission fluid should be used to lubricate the new seals before assembly. Who is correct?

When installing the forward clutch onto the overdrive clutch of a Ford 6R60 transmission, the new snap ring should be installed about __________ away from the original snap ring position.

What special tool is required to release the retaining ring that holds the carrier and the sun gear into the forward clutch on a Ford 6R60 transmission?

When reassembling the 6R60 transmission, the intermediate support housing must be placed so the locating tabs are in the:

The 6R60 transmission has seven shift solenoids.

How many planetary gears does the Ford 6R60 transmission contain?

Technician A says that all seven shift solenoids are variable force solenoids. Technician B says that all seven shift solenoids are on/off type solenoids. Who is correct?

When rebuilding the intermediate clutch assembly, all of the following statements with respect to measuring clutch pack clearance are true except:

The on/off solenoid should have a resistance of 10.5 ohms at room temperature.

The 6R60 transmission uses a single Lepellitier planetary gear set.