Exam 27: Ford 6r60 Zf6hp26

Tech A states that the 6R60 transmission has an output shaft speed sensor and a turbine shaft speed sensor. Tech B states that the turbine shaft speed sensor is a Hall Effect sensor. Who is correct?

A vehicle with a 6R60 transmission is towed to the shop with the transmission slipping in forward gears. Tech A states the problem could be a bad direct clutch. Tech B states that the problem could be a bad forward clutch. Who is correct?

Tech A states that the 6R60 transmission has an output shaft speed sensor and a turbine shaft speed sensor. Tech B states that the turbine shaft speed sensor is a Hall Effect sensor. Who is correct?

After reassembling the intermediate clutch assembly of a Ford 6R60 transmission, a dial indicator is set up on the pressure plate of the clutch assembly and two readings are taken 180° apart. What is the acceptable clutch pack clearance when an average of these two measurements is calculated?

All of the following solenoids receive a small amount of current from the PCM all of the time except:

Tech A states that the 6R60 transmission does not utilize a traditional dipstick. Tech B states that the transmission temperature must be around 180˚ F (82˚ C) in order to check the fluid. Who is correct?

Tech A states that when rebuilding a 6R60 transmission the frictions must be soaked in clean ATF for at least an hour. Tech B states that snap rings must be installed with the opening at specific positions. Who is correct?

Tech A states that based on the solenoid application chart, the 6R60 transmission does not have a fail-safe gear. Tech B states that 4th gear is a fail-safe gear. Who is correct?

Tech A states that on a 6R60 transmission the range sensor is a potentiometer that sends a voltage signal back to the PCM. Tech B states that the range sensor uses pressure switches to indicate gear selection. Who is correct?

Tech A states that based on the solenoid application chart, the 6R60 transmission does not have a fail-safe gear. Tech B states that 4th gear is a fail-safe gear. Who is correct?

A vehicle with a 6R60 transmission comes in to the shop with only 1st and 2nd gear. Tech A states the problem could be a bad low reverse clutch. Tech B states that the problem could be a bad range switch. Who is correct?

Tech A states that the 4th gear of a 6R60 transmission has a 1.14:1 ratio. Tech B states that the transmission does not have a true 1:1 ratio. Who is correct?

The Ford 6R60 transmission and the ZF6HP26 are the same basic transmissions with some minor component differences.

You are testing the solenoids from a 6R60 transmission and find that all of the solenoids have a resistance reading of 5.5 ohms except solenoid E which has 10.5 ohms. Tech A states that the solenoids will use more current than normal. Tech B states that the solenoids will use less current than normal. Who is correct?

Tech A states that when rebuilding a 6R60 transmission the frictions must be soaked in clean ATF for at least an hour. Tech B states that snap rings must be installed with the opening at specific positions. Who is correct?

Identify the operating frequency of the transmission range sensor of a 6R60 transmission.

The fluid level should only be checked when the transmission fluid temperature is between:

What is the duty cycle specification of a 6R60 transmission range sensor in the park position?

After reassembling the overdrive clutch assembly for a Ford 6R60 transmission, a dial indicator is set up on the pressure plate of the clutch assembly and two readings are taken 180° from one another. What is the acceptable clutch pack clearance when an average of these two measurements is calculated?

When rebuilding the forward clutch of a Ford 6R60 transmission, a paint pen should be used to draw a line between the forward clutch drum and the __________.