Exam 19: Transmission Reinstallation

The flexplate holes are not evenly spaced. This helps in:

Technician A says when installing the torque converter, make sure all three components, oil pump drive, stator support, and turbine input shaft, engage with their mating parts. Technician B says after rebuilding the transmission and installing it into the vehicle, it is not necessary to take a test drive or recheck the fluid level. Who is correct?

Tech A states that the transmission adaptives should be reset after you test drive the vehicle. Tech B states that the fluid level should be double checked after the initial test drive. Who is correct?

Before installing a new or rebuilt transmission, which of the following must be carefully cleaned and inspected?

Technician A says you can clean a transmission cooler and lines using the shop's parts cleaning tank. Technician B says you can clean a transmission cooler and lines with an aerosol flushing kit. Who is correct?

All of the following statements are true with respect to reinstalling the transmission except:

Tech A states that the transmission range switch should be adjusted before starting the vehicle after the transmission reinstallation. Tech B states that if the range switch is not adjusted the vehicle may not start. Who is correct?

A transmission fluid cooler that is leaking could cause all of the following except:

Which of these is not a common fault found when inspecting a flex plate?

All of the following statements are true with respect to reinstalling the transmission except:

Choose the correct statement with respect to transmission final checks.

Technician A says that the torque converter should be bolted to the flex plate before installing the transmission. Technician B says that when installing the torque converter, three separate engagements with their mating parts must be felt. Who is correct?

Tech A states that the gasket between the transmission and transfer case should be replaced when reinstalling the transmission. Tech B states that you should bolt the torque converter to the flexplate before installing the torque converter into the transmission. Who is correct?

The transmission cooler should always be cleaned before installing a new or rebuilt transmission.

Always verify the manufacturer's service information for any software updates before installing the transmission.

After the transmission is installed properly into the vehicle, approximately what percentage of the total transmission fluid should be added to the transmission?

Technician A says that after an initial test drive, the fluid level should be re-inspected. Technician B says that after the initial test drive, the vehicle and transmission should be re-inspected for leaks and all fasteners should be retorqued. Who is correct?

The aerosol can transmission cooler cleaning canister is usually good for three or four coolers before it needs replacing.

Technician A says when installing the torque converter, make sure all three components, oil pump drive, stator support, and turbine input shaft, engage with their mating parts. Technician B says when installing the torque converter, if the torque converter bolts line up with the flex plate holes, you can be sure that it is installed into the transmission properly. Who is correct?

Technician A says you can clean a transmission cooler and lines using the shop's parts cleaning tank. Technician B says you can clean a transmission cooler and lines with an aerosol flushing kit. Who is correct?