Exam 19: Transmission Reinstallation

Tech A states that transmission electrical connectors should be filled with RTV to prevent water from getting into the contacts. Tech B states that the seals on electrical connectors should be checked for damage and replaced if they are damaged. Who is correct?

Tech A states that the transmission range switch should be adjusted before starting the vehicle after the transmission reinstallation. Tech B states that if the range switch is not adjusted the vehicle may not start. Who is correct?

Technician A says when replacing an automatic transmission, it is critical to clean and inspect the transmission fluid cooler and lines. Technician B says metal particles and clutch material can become stuck inside the fluid cooler or fluid cooler lines. Who is correct?

Tech A states that on many new vehicles the PCM/TCM needs to be reflashed after rebuilding the transmission. Tech B states that many manufacturers will release updated software for PCM/TCMs after a vehicle has been manufactured. Who is correct?

Before installing a new or rebuilt transmission, which of the following must be carefully cleaned and inspected?

Tech A states that the transmission adaptives should be reset after you test drive the vehicle. Tech B states that the fluid level should be double checked after the initial test drive. Who is correct?

Technician A says that before test driving a recently rebuilt transmission, all DTCs should be erased. Technician B says that any cable adjustments should be verified before test driving. Who is correct?

After the transmission is installed properly into the vehicle, approximately what percentage of the total transmission fluid should be added to the transmission?

Technician A says it is critical to clean and inspect the transmission fluid cooler and lines. Technician B says metal particles and clutch material can become stuck inside the fluid cooler or fluid cooler lines. Who is correct?

Which of the following is least likely to be a fault found when inspecting a flexplate and flexplate mounting area?

Technician A says that after an initial test drive, the fluid level should be re-inspected. Technician B says that after the initial test drive, the vehicle and transmission should be re-inspected for leaks and all fasteners should be retorqued. Who is correct?

What precaution could be taken when reinstalling a half shaft if your area uses excessive amounts of road salt in the winter?

Using an impact gun to tighten up the axle retaining nut will:

Transmission coolers can be cleaned by:

The technician should add fluid to the transmission until it reaches which point dipstick when performing the final checks to an automatic transmission.