Question 1

When disassembling the 6T40 transmission, removal of which component will also require removal of the center support from the transmission?

Accepted Answer

A)  Front planet carrier and two thrust bearings 
B)  Center carrier 
C)  Low mechanical diode 
D)  Input shaft, along with the overdrive and direct clutch assembly 
A)  Front planet carrier and two thrust bearings 
B)  Center carrier 
C)  Low mechanical diode 
D)  Input shaft, along with the overdrive and direct clutch assembly A

Question 2

A customer brings in a vehicle with a 6T40/6F35 transmission for a transmission fluid change. Tech A states that the transmission fluid should be changed when the transmission is cold. Tech B states that the transmission fluid should only be drained when the transmission is hot. Who is correct?

Accepted Answer

A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B 
A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B D

Question 3

Tech A states that the 6T40 transmission utilizes a temperature-sensitive fluid level control valve. Tech B states the 6T40 transmission utilizes a solenoid actuated control valve. Who is correct?

Accepted Answer

A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B 
A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B A

Question 4

Tech A states that both the Ford and GM transmissions require petroleum ATF. Tech A states that both the Ford and GM transmissions require synthetic transmission fluid. Who is correct?

Accepted Answer

A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B 
A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B

Question 5

The 6T40 transmission uses a temperature sensitive fluid control valve that allows fluid to return to the sump area until it reaches 60°F.

Accepted Answer

A) True 
 B)False

Question 6

Technician A says that the Ford transmission fluid level can be inspected with a dipstick. Technician B says that the GM transmission can also be inspected with a dipstick. Who is correct?

Accepted Answer

A)  Technician A 
B)  Technician B 
C)  Both technicians 
D)  Neither technician 
A)  Technician A 
B)  Technician B 
C)  Both technicians 
D)  Neither technician

Question 7

Transmission fluid must be drained when its temperature is:

Accepted Answer

A)  above 140˚ F (60˚ 
C) . 
B)  below 140˚ F (60˚ 
C) . 
C)  above 100˚ F (37.78˚ 
C) . 
D)  below 100˚ F (37.78˚ 
C) . 
A)  above 140˚ F (60˚ 
C) . 
B)  below 140˚ F (60˚ 
C) . 
C)  above 100˚ F (37.78˚ 
C) . 
D)  below 100˚ F (37.78˚ 
C) .

Question 8

Which of the following should be removed before the reservoir for the transmission fluid could be removed?

Accepted Answer

A)  Fluid baffle 
B)  Parking pawl and spring 
C)  Drive and driven sprockets 
D)  Forward clutch 
A)  Fluid baffle 
B)  Parking pawl and spring 
C)  Drive and driven sprockets 
D)  Forward clutch

Question 9

Technician A says that the transmission fluid level of GM transmission must be inspected with a dipstick. Technician B says that the transmission fluid level of GM transmission must be inspected by removing a special plug. Who is correct?

Accepted Answer

A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B 
A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B

Question 10

Technician A says that the shift solenoids A, B, C, and D are on and off solenoids. Technician B says that shift solenoid E is the only variable-force solenoid. Who is correct?

Accepted Answer

A)  Technician A 
B)  Technician B 
C)  Both technicians 
D)  Neither technician 
A)  Technician A 
B)  Technician B 
C)  Both technicians 
D)  Neither technician

Question 11

A customer brings in a vehicle with a 6T40/6F35 transmission for a transmission fluid change. Tech A states that the transmission fluid should be changed when the transmission is cold. Tech B states that the transmission fluid should only be drained when the transmission is hot. Who is correct?

Accepted Answer

A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B 
A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B

Question 12

Identify the component of 6T40 transmission shown in the given figure

Accepted Answer

A)  Transfer chain arrangement 
B)  Drive and driven sprockets 
C)  Variable-force solenoid 
D)  Forward clutch 
A)  Transfer chain arrangement 
B)  Drive and driven sprockets 
C)  Variable-force solenoid 
D)  Forward clutch

Question 13

Tech A states that both the Ford and GM transmissions require petroleum ATF. Tech A states that both the Ford and GM transmissions require synthetic transmission fluid. Who is correct?

Accepted Answer

A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B 
A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B

Question 14

A vehicle with a 6T40/6F35 transmission comes into the shop with a customer compliant of the transmission slipping. You test drive the vehicle and find that it is slipping in 1st gear. Tech A says this could be caused by a bad low reverse clutch. Tech B states this could be caused by a bad one-way roller. Who is correct?

Accepted Answer

A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B 
A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B

Question 15

Which of these is the only overdrive ratio?

Accepted Answer

A)  Fourth gear 
B)  Fifth gear 
C)  Sixth gear 
D)  Seventh gear 
A)  Fourth gear 
B)  Fifth gear 
C)  Sixth gear 
D)  Seventh gear

Question 16

When reassembling the transmission, which of the following is done to ensure proper measurement of the clutch?

Accepted Answer

A)  Measure without installing frictions and steel into the case. 
B)  Use a feeler gauge along with a digital caliper to get precise readings. 
C)  Check in at least 10 places to ensure correctness. 
D)  Swap the top friction and steel temporarily so that a steel is on the top of the clutch pack. 
A)  Measure without installing frictions and steel into the case. 
B)  Use a feeler gauge along with a digital caliper to get precise readings. 
C)  Check in at least 10 places to ensure correctness. 
D)  Swap the top friction and steel temporarily so that a steel is on the top of the clutch pack.

Question 17

Technician A says that the 6T40 GM transmission uses DEXRON VI transmission fluid . Technician B says that the 6T40 GM transmission uses DEXRON IIE transmission fluid . Who is correct?

Accepted Answer

A)  Technician A 
B)  Technician B 
C)  Both technicians 
D)  Neither technician 
A)  Technician A 
B)  Technician B 
C)  Both technicians 
D)  Neither technician

Question 18

Identify the type of transmission fluid used by Ford 6F35 transmission.

Accepted Answer

A)  ATF+4 
B)  Dexron VI 
C)  Type F ATF 
D)  MERCON LV 
A)  ATF+4 
B)  Dexron VI 
C)  Type F ATF 
D)  MERCON LV

Question 19

Which of the following statements is NOT true regarding the 6T40 transmission?

Accepted Answer

A)  The transmission filter cannot be replaced without disassembling the transmission 
B)  The sixth gear is the only overdrive gear. 
C)  There are six planetary gears. 
D)  There are five shift solenoids. 
A)  The transmission filter cannot be replaced without disassembling the transmission 
B)  The sixth gear is the only overdrive gear. 
C)  There are six planetary gears. 
D)  There are five shift solenoids.

Question 20

Two technicians are discussing the 6T40/6F35 transmission. Tech A states that the transmission uses a thermostat to control flow to the transmission cooler. Tech B states that the thermostat controls fluid level in the pan. Who is correct?

Accepted Answer

A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B 
A)  Tech A 
B)  Tech B 
C)  Both A and B 
D)  Neither A nor B

Exam 25: 6t40 6f35 Transmission

When disassembling the 6T40 transmission, removal of which component will also require removal of the center support from the transmission?

A customer brings in a vehicle with a 6T40/6F35 transmission for a transmission fluid change. Tech A states that the transmission fluid should be changed when the transmission is cold. Tech B states that the transmission fluid should only be drained when the transmission is hot. Who is correct?

Tech A states that the 6T40 transmission utilizes a temperature-sensitive fluid level control valve. Tech B states the 6T40 transmission utilizes a solenoid actuated control valve. Who is correct?

Tech A states that both the Ford and GM transmissions require petroleum ATF. Tech A states that both the Ford and GM transmissions require synthetic transmission fluid. Who is correct?

The 6T40 transmission uses a temperature sensitive fluid control valve that allows fluid to return to the sump area until it reaches 60°F.

Technician A says that the Ford transmission fluid level can be inspected with a dipstick. Technician B says that the GM transmission can also be inspected with a dipstick. Who is correct?

Transmission fluid must be drained when its temperature is:

Which of the following should be removed before the reservoir for the transmission fluid could be removed?

Technician A says that the transmission fluid level of GM transmission must be inspected with a dipstick. Technician B says that the transmission fluid level of GM transmission must be inspected by removing a special plug. Who is correct?

Technician A says that the shift solenoids A, B, C, and D are on and off solenoids. Technician B says that shift solenoid E is the only variable-force solenoid. Who is correct?

A customer brings in a vehicle with a 6T40/6F35 transmission for a transmission fluid change. Tech A states that the transmission fluid should be changed when the transmission is cold. Tech B states that the transmission fluid should only be drained when the transmission is hot. Who is correct?

Identify the component of 6T40 transmission shown in the given figure

Tech A states that both the Ford and GM transmissions require petroleum ATF. Tech A states that both the Ford and GM transmissions require synthetic transmission fluid. Who is correct?

Which of these is the only overdrive ratio?

When reassembling the transmission, which of the following is done to ensure proper measurement of the clutch?

Technician A says that the 6T40 GM transmission uses DEXRON VI transmission fluid . Technician B says that the 6T40 GM transmission uses DEXRON IIE transmission fluid . Who is correct?

Identify the type of transmission fluid used by Ford 6F35 transmission.

Which of the following statements is NOT true regarding the 6T40 transmission?

Two technicians are discussing the 6T40/6F35 transmission. Tech A states that the transmission uses a thermostat to control flow to the transmission cooler. Tech B states that the thermostat controls fluid level in the pan. Who is correct?

Strategy-Based Diagnostics

Safety

Basic Tools and Precision Measuring

Fasteners and Thread Repair

Vehicle, Customer, and Service Information

Automatic Transmission Fundamentals

Transmission Components

Hydraulic Fundamentals

Torque Converter Principles

Hydraulically Controlled Transmission

Electronically Controlled Transmission

In-Vehicle Transmission Repairs

Transmission Removal

Transmission Disassembly

Hydraulic System Rebuilding

Gear Train Rebuilding

Valve Body and Electric Service

Transmission Reassembly

Transmission Reinstallation

Dual Clutch Transmissions

Continuously Variable Transmissions

Hybrid Transmissions

Honda Transmissions

Chrysler 6 Speed 62te Transmission

Zf 9hp Chrysler 948te Transmission

Ford 6r60 Zf6hp26

Allison 1000 and 2000 Series Transmissions

Filters