Exam 27: Ford 6r60 Zf6hp26

Tech A states that the transmission range sensor of a 6R60 transmission is a traditional switch. Tech B states that the transmission range sensor is a Hall Effect sensor. Who is correct?

Tech A says that the 6R60 does not have an overdrive gear. Tech B says that the 6R60 is a dual overdrive unit. Who is correct?

Tech A states that the transmission fluid temperature is not related in any way to the transmission fluid level. Tech B states that if the fluid temperature is incorrect when the fluid level is checked, an incorrect reading may result. Who is correct?

Tech A states that the 6R60 shift solenoids are pulse width modulated. Tech B states that the shift solenoids are variable force solenoids. Who is correct?

After reassembling the forward clutch assembly of a Ford 6R60 transmission, a dial indicator is set up on the pressure plate of the clutch assembly and two readings are taken 180° apart. What is the acceptable clutch pack clearance when an average of these two measurements is calculated?

The Ford 6R60 transmission is designed from the ________ transmission.

The Ford 6R60 transmission is designed from the ________ transmission.

What should be the resistance of shift solenoid E at room temperature?

Technician A says that the 6R60 transmission has a short dipstick underneath the fill plug. Technician B says that the transmission fluid level of 6R60 transmission can only be checked with a scan tool. Who is correct?

The sixth gear of a 6R60 transmission uses a gear ratio of ________

Disassembly of a Ford 6R60 overdrive clutch is being discussed. Technician A says to mark the snap ring opening before removing the snap ring. Technician B says to pry only 180° from the snap ring opening mark or the forward clutch housing will be destroyed. Who is correct?

During assembly of the 6R60 transmission, the service procedure states to measure the thickness of the low/reverse clutch pack and record the measurement. What components are included in that measurement?

The Ford 6R60 transmission uses a single ________

For how long should all frictions be soaked in the specified automatic transmission fluid before being installed into the transmission?

A vehicle comes in with a 6R60 transmission with a burned overdrive clutch. Tech A states the problem could be a bad shift solenoid "E." Tech B states the problem could be a bad shift solenoid "C." Who is correct?

The fluid level should only be checked when the transmission fluid temperature is between:

Tech A states that the 6R60 transmission does not contain any brake bands or dog clutches. Tech B states that the 6R60 transmission does not have a dog clutch, but uses brake bands. Who is correct?

Technician A says that all pre-2011 transmissions will have a TCM mounted to the transmission valve body. Technician B says that all transmissions are controlled by the PCM, regardless of the year. Who is correct?

When rebuilding the forward/overdrive clutch assembly, what should be the position of the new snap ring with respect to the position of the original snap ring opening?

Technician A says that some heavy-duty versions of the 6R60 transmission utilizes a one-way roller clutch to help with engine braking. Technician B says that the 6R80 is a heavy-duty versions of the 6R60 transmission. Who is correct?