Exam 4: Cisco Certified Network Associate (CCNA)

A manager asks a network engineer to advise which cloud service models are used so employees do not have to waste their time installing, managing, and updating software that is only used occasionally. Which cloud service model does the engineer recommend?

Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?

What benefit does controller-based networking provide versus traditional networking?

Which action does the router take as it forwards a packet through the network?

The OSPF Hello protocol performs which of the following tasks? (Choose two.)

If a notice-level message is sent to a syslog server, which event has occurred?

What are two functions of a Layer 2 switch? (Choose two.)

Which statement correctly compares traditional networks and controller-based networks?

What are two descriptions of three-tier network topologies? (Choose two.)

An engineer must configure a WLAN using the strongest encryption type for WPA2-PSK. Which cipher fulfills the configuration requirement?

Which WAN access technology is preferred for a small office / home office architecture?

Which type of authentication and encryption does SNMPv3 use at the authPriv security level?

Refer to the exhibit. After you apply the given configurations to R1 and R2 you notice that OSPFv3 fails to start.

Refer to the exhibit. The network administrator wants VLAN 67 traffic to be untagged between Switch 1 and Switch 2, while all other VLANs are to remain tagged. Which command accomplishes this task?

A user configured OSPF in a single area between two routers. A serial interface connecting R1 and R2 is running encapsulation PPP. By default, which OSPF network type is seen on this interface when the user types show ip ospf interface on R1 or R2?

Refer to the exhibit. If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10.13.0.1 120 command, how does the router respond?

Refer to the exhibit. Router R2 is configured with multiple routes to reach network 10.1.1.0/24 from router R1. Which path is chosen by router R2 to reach the destination network 10.1.1.0/24?

Which feature on the Cisco Wireless LAN Controller when enabled restricts management access from specific networks?

An office has 8 floors with approximately 30-40 users per floor. One subnet must be used. Which command must be configured on the router Switched Virtual Interface to use address space efficiently?

Refer to the exhibit. Which action do the switches take on the trunk link?