Exam 1: BICSI Registered Communications Distribution Designer - RCDD

Select the appropriate task to complete section 2.2 of the work breakdown structure (WBS) below: 2 Technician 2.1 Install cabling 2.2 __________ 2.3 Activate wireless

An open office design is made up of three furniture clusters and contains a total of nine. How many multiuser telecommunications outlet assemblies (MUTOA) should be in the design?

Which is an advantage of stranded conductors over solid conductors?

Buildings larger than ________ must contain a dedicated room for the termination of entrance facilities.

You have just assumed management responsibility over an older network consisting of passive hubs and some layer 2 switches. The network is experiencing massive slow downs on an irregular basis. Which of the following is the MOST effective immediate solution to the problem?

Within a commercial office building of 2300 sq m (25000 sq ft), how many building automation system (BAS) devices are required?

What type of estimate is based on the cost of performing similar work in the past, adjusted for current job conditions?

A building has six floors plus a basement. Each floor is 10,000 square feet and has approximately 50 CATV outlets respectively. There is a single hardline trunk cable installed from the basement headend passing through the telecommunications room (TR) on each floor. What is usually the MOST cost effective coaxial cable design to implement on the horizontal distribution from the telecommunications room (TR)?

Color codes for cross-connection fields have been used for many years. Which color is used to identify network connections?

When labeling pathways, which one of the following guidelines should be met?

Exhibit: The following diagram indicates what type of CATV distribution system?

The ability of a device to withstand electromagnetic disturbances from another device is:

A scope of work should contain all of the following EXCEPT:

You have been asked to project manage a fiber cable backbone installation. In the course of the installation, you notice the fiber cable with a 25 mm (1 in) outside diameter is being installed into a small TR, and the cable is being installed into a tight corner. Based on your knowledge of minimum bend radius requirements for fiber cable, you must ensure that the MINIMUM cable bend radius of _______________ is provided when the cable installation is completed.

A campus backbone design linking two buildings requires that you install a high-fiber-count cable very quickly, using the conduit system provided. Cost is not so much an issue as urgency is to meet a service demand. Your first choice of fiber cable installation is to use:

What is the horizontal separation, in well tamped earth, required between power and direct buried telecommunications facilities sharing the same trench?

An active video converter is used in what type of CATV cable distribution system?

Certain systems must exist relative to bonding and grounding at every site. Which of the following is NOT one such system?

This type of cable is an unbalanced system:

What is the PERT estimate (in hours) for project design where: - Optimistic time is 40 hours - Most likely time is 50 hours - Pessimistic time is 60 hours