Exam 1: BICSI Registered Communications Distribution Designer - RCDD

Wave division multiplexing (WDM) is most similar to:

MAC addresses are _____________ bits in length.

Which device uses circulators or diplexer filters to separate and combine the different transmit and receive RF paths?

The propagation and path loss of radio signals in the target environment can be sampled using:

You have been selected to recommend a solution to increase response time and add fault tolerance to a bank of servers. Your budget is limited and the client needs a solution as soon as possible (ASAP). Which of the following options should be considered with the short time frame and limited budget?

Which layer of the OSI model covers physical cable connections?

As a guide, the MAXIMUM recommended DC current value on any bonded conductor should be less than:

Exhibit: The diagram below is a typical configuration for:

Which of the following is NOT a primary method of transporting radio signals in an active DAS?

A conduit run is installed from the ER to a TR. It has two (2) 90 degree bend and a length of 20 m (65 ft). What will be the MINIMUM test rating of the pull cord left in the conduit?

From a 1000 ft (305 m) roll of optical fiber, how many MAXIMUM length centralized optical fiber cabling runs can be made?

At the end of the third week of a project, the actual cost of work performed is $7000 USd and the budgeted cost of work performed is $8000 USd. Which of the following is true?

Which of the following is NOT a type of intrusion detection system sensor?

Which of the following is NOT an example of a perimeter pathway?

The impedance of the equipment grounding conductor can only be accurately measured with an instrument known as a(n):

You have been asked to design a backbone cable connecting two large campus buildings. Your pathways will include using conduits, maintenance holes, and one section of 100 m (328 ft) of direct buried optical fiber cable. Your choice of fiber optic cable type recommendation is a:

Which is NOT a type of contract?

Exhibit: In this future marina layout, assuming that there are fewer than 10 slips being cabled, what would be the pre-cabling guideline to follow for terminal A?

When allocating termination space for CAT 6 and optical fiber cables, it is recommended that additional space of up to ________ percent be considered for the routing of the cables and patch cords.

Optical transmitters are typically one of the following types EXCEPT: