Exam 5: Hand Tools and Shop Equipment

The bolts used to attach an engine sling to the engine must thread into the cylinder head or block _____ times the diameter of the bolt.

A(n)____________________ extension allows the socket to pivot up to 16 degrees.

Technician A says a tap cuts external threads. Technician B says a die cuts internal threads. Who is correct?

Metric and SAE wrenches are interchangeable.

A(n)____________________ gauge is a thin strip of metal or plastic of known and closely controlled thickness.

Identify some common uses of a dial indicator.

The ____________________ wrench has an open-end jaw on one end and a box-end on the other.

A measurement must be made within one ten-thousandth of an inch. Technician A uses a machinist's rule. Technician B uses a standard micrometer. Who is correct?

What are some safety issues concerning the use of power tools?

A(n)____________________ press is used to install piston pins, axle bearings, drum and rotor studs.

What determines the size of an open-end wrench?

When driving out rusted bolts, Technician A places the round end of a ball-peen hammer over the bolt and then hits the flat end of the ball-peen hammer with a sledge hammer. Technician B uses a Phillips tip screwdriver and a ball peen hammer to drive out small rusted bolts. Who is correct?

When you turn on a grinder, where should you be standing?

One liter equals 61.02 cubic inches.

If the number 8.8 is stamped on the head of a bolt, the bolt is ______.

Technician A says a bolt may break because the fillet is damaged. Technician B says that a bolt may become fatigued and break if it is undertightened. Who is correct?

A straightedge and feeler gauge are used to measure _____.

Which screwdriver design has a square tip?

Technician A torques critical parts using an impact wrench. Technician B torques critical parts with an air ratchet. Who is correct?

What is the best source for vehicle identification?