Exam 5: Hand Tools and Shop Equipment

A telescoping gauge is also called a(n)____________________ gauge.

Name the eight parts of a bolt.

Technician A uses a punch to align holes in parts during assembly. Technician B uses a punch to drive out rivets. Who is correct?

One inch equals 2.54 centimeters.

How are hammers identified?

A dial caliper is accurate to _____ inch.

Which of the following types of pliers is best for grasping small parts?

When installing a new hacksaw blade, the teeth should face rearward.

The best method to use to loosen a bolt is ______.

A(n)____________________ hammer should be used to install gears and shafts in a transmission.

A 12-point socket has more grip than a 6-point socket.

Technician A uses a small hole gauge and micrometer to measure the inside diameters of small bores. Technician B uses a dial caliper to take depth measurements. Who is correct?

To avoid personal injury, you should always use files with a(n)____________________.

Technician A says a vernier caliper can be used to measure the outside diameter of something. Technician B says a vernier caliper can be used to measure the inside diameter of a bore. Who is correct?

What type of wrench should be used to loosen or tighten brake lines or tubing fittings?

Describe the proper usage of a hacksaw.

The tensile strength of a metric bolt can be identified by ______.

An extractor is used for removing broken ______.

A(n)____________________ manual contains standards for the length of time a specific repair is supposed to require.

Ten inch pounds of torque equals 13.558 Newton (N)meters.