Question 1

Which of the following allows a 16-bit Rambus to operate at speeds higher than that of a conventional 64-bit memory bus?

Accepted Answer

A) Internal data channel 
B) Diode circuitry 
C) Low switching speeds 
D) Error Checking and Correction 
A) Internal data channel 
B) Diode circuitry 
C) Low switching speeds 
D) Error Checking and Correction

Question 2

Which of the following POST card operational modes should you use if you want to specify the system components that should be tested?

Accepted Answer

A) Extended Diagnostics mode 
B) Forced Start mode 
C) Basic Diagnostics mode 
D) Advanced Start mode 
A) Extended Diagnostics mode 
B) Forced Start mode 
C) Basic Diagnostics mode 
D) Advanced Start mode

Question 3

You purchase a new RAM chip and want to install it on your server. You test the chip on an identical test server and find that it is compatible. However when you place the chip on the actual server, the new memory is not recognized. What is the most likely cause of the RAM not being recognized on the actual server?

Accepted Answer

A) The actual server's motherboard already has the maximum amount of RAM supported. 
B) You must install new RAM chips in pairs, not individually. 
C) The RAM is faulty. 
D) The RAM is not supported on the actual server. 
A) The actual server's motherboard already has the maximum amount of RAM supported. 
B) You must install new RAM chips in pairs, not individually. 
C) The RAM is faulty. 
D) The RAM is not supported on the actual server.

Question 4

Which of the following components prevents the processor from overheating and damage?

Accepted Answer

A) Heat-sink and Cooling fan 
B) Heat-sink, Cooling Fan, and Thermal grease 
C) Cooling Fan and Thermal grease 
D) Heat-sink and Thermal grease 
A) Heat-sink and Cooling fan 
B) Heat-sink, Cooling Fan, and Thermal grease 
C) Cooling Fan and Thermal grease 
D) Heat-sink and Thermal grease

Question 5

Which of the following hard drive parameters indicate the symptoms of a server bottleneck?

Accepted Answer

A) Percentage disk time greater than 50% and Avg. Read Queue Length of 4 
B) Percentage disk time greater than 50% and Avg. Read Queue Length of 3 
C) Percentage disk time greater than 40% and Avg. Read Queue Length of 4 
D) Avg. Write Queue Length of 1 and Avg. Read Queue Length of 4 
A) Percentage disk time greater than 50% and Avg. Read Queue Length of 4 
B) Percentage disk time greater than 50% and Avg. Read Queue Length of 3 
C) Percentage disk time greater than 40% and Avg. Read Queue Length of 4 
D) Avg. Write Queue Length of 1 and Avg. Read Queue Length of 4

Question 6

Which of the following is a prime advantage of having a server rack?

Accepted Answer

A) Eliminates the need for multiple cooling fans 
B) Eliminates the need for multiple RAM modules 
C) Eliminates any worries about environmental factors 
D) Racks have low friction rails for easy access 
A) Eliminates the need for multiple cooling fans 
B) Eliminates the need for multiple RAM modules 
C) Eliminates any worries about environmental factors 
D) Racks have low friction rails for easy access

Question 7

Which of the following active offsite storage backup facilities is continuously connected to the server that is currently operating?

Accepted Answer

A) Warm site 
B) Cold site 
C) Hot site 
D) Continuous site 
A) Warm site 
B) Cold site 
C) Hot site 
D) Continuous site

Question 8

How many tapes are required for each category in the grandfather-father-son backup implementation?

Accepted Answer

A) Grandfather = 4, father = 1, son = 1 
B) Grandfather = 1, father = 1, son = 4 
C) Grandfather = 1, father = 4, son = 1 
D) Grandfather = 1, father = 1, son = 1 
A) Grandfather = 4, father = 1, son = 1 
B) Grandfather = 1, father = 1, son = 4 
C) Grandfather = 1, father = 4, son = 1 
D) Grandfather = 1, father = 1, son = 1

Question 9

Which of the following procedures should you not follow when moving a full server rack?

Accepted Answer

A) Remove the components before moving the rack. 
B) Make sure you unplug the components before moving the rack. 
C) Clear everything in your path before moving the rack. 
D) Move the server rack to its new destination without removing its components. 
A) Remove the components before moving the rack. 
B) Make sure you unplug the components before moving the rack. 
C) Clear everything in your path before moving the rack. 
D) Move the server rack to its new destination without removing its components.

Question 10

David wants to verify whether a host on his network can connect to the internet. Which of the following utilities should he use?

Accepted Answer

A) TRACERT 
B) NETSTAT 
C) NBTSTAT 
D) PING 
A) TRACERT 
B) NETSTAT 
C) NBTSTAT 
D) PING

Question 11

David is troubleshooting his computer, which does not start up. The issue occurs immediately after the system fan powers up. Which of the following could be causing this problem?

Accepted Answer

A) Processor 
B) Hard drive 
C) Motherboard 
D) Monitor 
A) Processor 
B) Hard drive 
C) Motherboard 
D) Monitor

Question 12

Which of the following specifies the benefits of a rack-mounted server?

Accepted Answer

A) It cools down servers. 
B) It is more affordable. 
C) It provides redundancy. 
D) It optimizes server space. 
A) It cools down servers. 
B) It is more affordable. 
C) It provides redundancy. 
D) It optimizes server space.

Question 13

Which of the following RAID implementation types features disk striping and a dedicated parity drive?

Accepted Answer

A) RAID-0 
B) RAID-1 
C) RAID-3 
D) RAID-5 
A) RAID-0 
B) RAID-1 
C) RAID-3 
D) RAID-5

Question 14

What is the network ID for an IP address of 110.168.200.15?

Accepted Answer

A) 110.168.200.0 
B) 0)0.200.15 
C) 110.0.0.0 
D) 110.168.0.0 
A) 110.168.200.0 
B) 0)0.200.15 
C) 110.0.0.0 
D) 110.168.0.0

Question 15

Which of the following is the easiest way to distinguish an NLX motherboard?

Accepted Answer

A) It has both IDD and SATA sockets. 
B) It has 3 memory slots. 
C) It has dual processor slots. 
D) The expansion cards connect to the riser card. 
A) It has both IDD and SATA sockets. 
B) It has 3 memory slots. 
C) It has dual processor slots. 
D) The expansion cards connect to the riser card.

Question 16

You have attached a SCSI scanner to a server. Prior to the scanner installation, all the devices attached to the systems were working properly. After the installation, the system does not boot properly. Which of the following could be the most likely cause of this issue?

Accepted Answer

A) Scanner is not terminated properly. 
B) Scanner is not connected to the network. 
C) Scanner is not powering up. 
D) Server is disconnected from the network. 
A) Scanner is not terminated properly. 
B) Scanner is not connected to the network. 
C) Scanner is not powering up. 
D) Server is disconnected from the network.

Question 17

You have tested an upgrade plan in a controlled environment and are ready to do the upgrade in the production environment. Which of the following should you do before you take a server and its resources offline?

Accepted Answer

A) Disconnect users from the server. 
B) Notify users of the server downtime. 
C) Disconnect the server. 
D) Directly implement the upgrade plan. 
A) Disconnect users from the server. 
B) Notify users of the server downtime. 
C) Disconnect the server. 
D) Directly implement the upgrade plan.

Question 18

You have installed TCP/IP on one of your network servers. You want to test to make sure that it is initialized properly on the server. Which of the following commands should you use?

Accepted Answer

A) Ping 127.0.0.1 
B) Tracert hostname 
C) PING hostname 
D) Ipconfig 127.0.0.1 
A) Ping 127.0.0.1 
B) Tracert hostname 
C) PING hostname 
D) Ipconfig 127.0.0.1

Question 19

David has just installed the Wake-On-LAN card on his server. He tries to boot the remote servers and is unable to do so. Which of the following packets could be the cause of the issue?

Accepted Answer

A) Magic packet 
B) SNMP packet 
C) TCP/IP packet 
D) IP packet 
A) Magic packet 
B) SNMP packet 
C) TCP/IP packet 
D) IP packet

Question 20

Which of the following provides the best possible opportunity to upgrade the system BIOS?

Accepted Answer

A) Upgrading Hard drive 
B) Upgrading Processor 
C) Upgrading SCSI drive 
D) Upgrading RAM 
A) Upgrading Hard drive 
B) Upgrading Processor 
C) Upgrading SCSI drive 
D) Upgrading RAM

Exam 26: Server

Which of the following allows a 16-bit Rambus to operate at speeds higher than that of a conventional 64-bit memory bus?

Which of the following POST card operational modes should you use if you want to specify the system components that should be tested?

Which of the following components prevents the processor from overheating and damage?

Which of the following hard drive parameters indicate the symptoms of a server bottleneck?

Which of the following is a prime advantage of having a server rack?

Which of the following active offsite storage backup facilities is continuously connected to the server that is currently operating?

How many tapes are required for each category in the grandfather-father-son backup implementation?

Which of the following procedures should you not follow when moving a full server rack?

David wants to verify whether a host on his network can connect to the internet. Which of the following utilities should he use?

David is troubleshooting his computer, which does not start up. The issue occurs immediately after the system fan powers up. Which of the following could be causing this problem?

Which of the following specifies the benefits of a rack-mounted server?

Which of the following RAID implementation types features disk striping and a dedicated parity drive?

What is the network ID for an IP address of 110.168.200.15?

Which of the following is the easiest way to distinguish an NLX motherboard?

You have attached a SCSI scanner to a server. Prior to the scanner installation, all the devices attached to the systems were working properly. After the installation, the system does not boot properly. Which of the following could be the most likely cause of this issue?

You have tested an upgrade plan in a controlled environment and are ready to do the upgrade in the production environment. Which of the following should you do before you take a server and its resources offline?

You have installed TCP/IP on one of your network servers. You want to test to make sure that it is initialized properly on the server. Which of the following commands should you use?

David has just installed the Wake-On-LAN card on his server. He tries to boot the remote servers and is unable to do so. Which of the following packets could be the cause of the issue?

Which of the following provides the best possible opportunity to upgrade the system BIOS?

Hardware

Laptops

Networking

Printers

Procedures

Other Operating Systems and Technologies

Mobile-Devices

Operating-Systems

Security

Troubleshooting

Access-Identity

Apps - Data - Host

Compliance-Op

Comptia Asp

Concepts

Cryptography

Dhti

Enrolled-Agent

Essentials

Install Configure

Linux

Management

Media Topologies

Network

Other-Operating-Systems-And-Technologies

Software-Troubleshooting

Threats

Filters