Question 1

Which of the following precisely specify the purpose of using redundant NICs on a server?

Accepted Answer

A) To reduce network traffic. 
B) To increase the speed of the server. 
C) To keep the network available in the event that one NIC fails. 
D) To reduce the amount of data loss when packets are transferred. 
A) To reduce network traffic. 
B) To increase the speed of the server. 
C) To keep the network available in the event that one NIC fails. 
D) To reduce the amount of data loss when packets are transferred.

Question 2

Which of the following servers allows clients to access network resources by computer name rather than by IP address?

Accepted Answer

A) WINS server 
B) RAS server 
C) NAS server 
D) DHCP server 
A) WINS server 
B) RAS server 
C) NAS server 
D) DHCP server

Question 3

What is the minimum number of steps required to create a disaster recovery plan?

Accepted Answer

A) Five 
B) Seven 
C) Six 
D) Eight 
A) Five 
B) Seven 
C) Six 
D) Eight

Question 4

Which of the following is a default port number used by the SNMP protocol?

Accepted Answer

A) 100 
B) 85 
C) 161 
D) 25 
A) 100 
B) 85 
C) 161 
D) 25

Question 5

Which of the following SCSI interfaces uses one half of the wires for the cable that transfers data and control mechanisms and the other half for a ground point?

Accepted Answer

A) SE 
B) LVD 
C) FPT 
D) HVD 
A) SE 
B) LVD 
C) FPT 
D) HVD

Question 6

You are troubleshooting a server after you have installed an NIC on the network. You run a set of diagnostic tests on the NIC. These tests reveal no problems. Which of the following troubleshooting steps need not be performed?

Accepted Answer

A) Checking the cable connections 
B) Reviewing network software configuration settings 
C) Pinging other computers on the network 
D) Replacing the present NIC with a good one 
A) Checking the cable connections 
B) Reviewing network software configuration settings 
C) Pinging other computers on the network 
D) Replacing the present NIC with a good one

Question 7

Which of the following should happen in a boot process after the BIOS setup is displayed on the monitor?

Accepted Answer

A) Power supply switches ON 
B) FDD light appears 
C) System gives a count of system memory 
D) Keyboard lights start flashing 
A) Power supply switches ON 
B) FDD light appears 
C) System gives a count of system memory 
D) Keyboard lights start flashing

Question 8

David is a network administrator for his organization. The organization has three servers and a domain. After performing an upgrade on the server that functions as the DHCP server, David reboots the server. He receives an error message that states "DHCP Service has failed to start." Where should he check for more information on this error?

Accepted Answer

A) F1-based help on Windows OS 
B) System log on the Event Viewer 
C) Application log on the Event Viewer 
D) Microsoft's support website 
A) F1-based help on Windows OS 
B) System log on the Event Viewer 
C) Application log on the Event Viewer 
D) Microsoft's support website

Question 9

Which of the following is the safest location for storing a Disaster Recovery Plan?

Accepted Answer

A) Offsite, on backup tapes 
B) Onsite and offsite, on backup tapes 
C) Onsite, on backup tapes 
D) Onsite and offsite, on zip drives 
A) Offsite, on backup tapes 
B) Onsite and offsite, on backup tapes 
C) Onsite, on backup tapes 
D) Onsite and offsite, on zip drives

Question 10

You are trying to troubleshoot a monitor that has a dead screen. The brightness and contrast controls are turned up and you now want to check if the monitor display is working. What should you do?

Accepted Answer

A) Clean the screen with a dry cloth. 
B) Switch ON the computer and feel the static on the screen. 
C) Clean the screen with a wet cloth. 
D) Switch OFF and then switch ON the monitor. 
A) Clean the screen with a dry cloth. 
B) Switch ON the computer and feel the static on the screen. 
C) Clean the screen with a wet cloth. 
D) Switch OFF and then switch ON the monitor.

Question 11

Which of the following termination types does SCSI-1 networks normally use?

Accepted Answer

A) Active 
B) HVD 
C) Passive 
D) LVD 
A) Active 
B) HVD 
C) Passive 
D) LVD

Question 12

How many devices can be connected to a two-channel SCSI-3 RAID 5 controller?

Accepted Answer

A) 55 
B) 40 
C) 100 
D) 30 
A) 55 
B) 40 
C) 100 
D) 30

Question 13

What is the maximum number of nodes supported by Network Load Balancing?

Accepted Answer

A) 32 
B) 4 
C) 8 
D) 16 
A) 32 
B) 4 
C) 8 
D) 16

Question 14

Which of the following differentiates between disk mirroring and disk duplexing?

Accepted Answer

A) Disk mirroring uses one controller for both drives, whereas disk duplexing uses one controller for each drive. 
B) Disk mirroring uses a minimum of three drives, whereas disk duplexing uses two. 
C) Disk duplexing uses a single controller for both drives, whereas disk mirroring uses one controller for each drive. 
D) Disk mirroring strips data, whereas disk duplexing shares data parity disks. 
A) Disk mirroring uses one controller for both drives, whereas disk duplexing uses one controller for each drive. 
B) Disk mirroring uses a minimum of three drives, whereas disk duplexing uses two. 
C) Disk duplexing uses a single controller for both drives, whereas disk mirroring uses one controller for each drive. 
D) Disk mirroring strips data, whereas disk duplexing shares data parity disks.

Question 15

Which of the following connector types should be used to terminate CAT5e cabling?

Accepted Answer

A) RJ-11 
B) RJ-14 
C) RJ-35 
D) RJ-45 
A) RJ-11 
B) RJ-14 
C) RJ-35 
D) RJ-45

Question 16

Which of the following technologies will support an array composed of five servers handling 400 hard drives?

Accepted Answer

A) Fiber Channel 
B) IEEE 1394 
C) Ultra ATA-33 
D) Ultra ATA-66 
A) Fiber Channel 
B) IEEE 1394 
C) Ultra ATA-33 
D) Ultra ATA-66

Question 17

John performed a full backup yesterday. However, management wants him make another backup today. Which of the following backup types should he perform to finish the backup procedure in the least amount of time?

Accepted Answer

A) Incremental backup 
B) Partial backup 
C) Differential backup 
D) Small backup 
A) Incremental backup 
B) Partial backup 
C) Differential backup 
D) Small backup

Question 18

You have performed a full backup of your server and have developed a rollback plan. Before upgrading this plan in the production environment, what should you do first?

Accepted Answer

A) Notify users that the server will be offline. 
B) Test the upgrade plan in a test environment. 
C) Move the resources to another network server. 
D) Document the server's configuration. 
A) Notify users that the server will be offline. 
B) Test the upgrade plan in a test environment. 
C) Move the resources to another network server. 
D) Document the server's configuration.

Question 19

Which of the following factors are considered when determining the best UPS size and type for a new server?

Accepted Answer

A) Voltage − Amperes 
B) Voltage /Amperes 
C) Voltage + Amperes 
D) Voltage * Amperes 
A) Voltage − Amperes 
B) Voltage /Amperes 
C) Voltage + Amperes 
D) Voltage * Amperes

Question 20

Which of the following directories does the floppy drive usually use to mount in a Linux operating system?

Accepted Answer

A) /dev/fd0 
B) /mnt/floppy 
C) \dev\fd0 
D) \mnt\floppy 
A) /dev/fd0 
B) /mnt/floppy 
C) \dev\fd0 
D) \mnt\floppy

Exam 26: Server

Which of the following precisely specify the purpose of using redundant NICs on a server?

Which of the following servers allows clients to access network resources by computer name rather than by IP address?

What is the minimum number of steps required to create a disaster recovery plan?

Which of the following is a default port number used by the SNMP protocol?

Which of the following SCSI interfaces uses one half of the wires for the cable that transfers data and control mechanisms and the other half for a ground point?

You are troubleshooting a server after you have installed an NIC on the network. You run a set of diagnostic tests on the NIC. These tests reveal no problems. Which of the following troubleshooting steps need not be performed?

Which of the following should happen in a boot process after the BIOS setup is displayed on the monitor?

Which of the following is the safest location for storing a Disaster Recovery Plan?

You are trying to troubleshoot a monitor that has a dead screen. The brightness and contrast controls are turned up and you now want to check if the monitor display is working. What should you do?

Which of the following termination types does SCSI-1 networks normally use?

How many devices can be connected to a two-channel SCSI-3 RAID 5 controller?

What is the maximum number of nodes supported by Network Load Balancing?

Which of the following differentiates between disk mirroring and disk duplexing?

Which of the following connector types should be used to terminate CAT5e cabling?

Which of the following technologies will support an array composed of five servers handling 400 hard drives?

John performed a full backup yesterday. However, management wants him make another backup today. Which of the following backup types should he perform to finish the backup procedure in the least amount of time?

You have performed a full backup of your server and have developed a rollback plan. Before upgrading this plan in the production environment, what should you do first?

Which of the following factors are considered when determining the best UPS size and type for a new server?

Which of the following directories does the floppy drive usually use to mount in a Linux operating system?

Hardware

Laptops

Networking

Printers

Procedures

Other Operating Systems and Technologies

Mobile-Devices

Operating-Systems

Security

Troubleshooting

Access-Identity

Apps - Data - Host

Compliance-Op

Comptia Asp

Concepts

Cryptography

Dhti

Enrolled-Agent

Essentials

Install Configure

Linux

Management

Media Topologies

Network

Other-Operating-Systems-And-Technologies

Software-Troubleshooting

Threats

Filters