Exam 24: Chrysler 6 Speed 62te Transmission

The pressure control solenoid on a Chrysler 62TE is being discussed. Technician A says that the duty cycle of 5% will give the transmission full line pressure. Technician B says that at 62% pulse width will give the transmission full line pressure. Who is correct?

Which of these is a common wear item and should always be replaced?

Tech A states that the 62TE transmission design is based upon the 41TE transmission. Tech B states that 62TE transmission design is based upon the 42RLE transmission. Who is correct?

The overrunning sprag of 62TE is held at all of the following except:

Identify the transmission fluid level for a fluid temperature of 191 degree Fahrenheit.

How many speed sensors need to be removed from the exterior case of a 62TE during disassembly?

The 62TE is a ________ front-wheel drive transmission.

All of the following statements with respect to rebuilding the low clutch housing are true except:

A vehicle comes in with no reverse. Tech A states that the vehicle could have a problem with the reverse clutch. Tech B states that the vehicle could have a problem with the low clutch. Who is correct?

Two technicians are discussing the 62TE transmission. Tech A states that the 6 speed transmission has 7 forward gear ratios and 1 reverse ratio. Tech B states that the transmission has 6 forward gear ratios and 1 reverse ratio. Who is correct?

Tech A states that a double swap shift would take a considerably longer amount of time to complete. Tech B states that a double swap shift would be noticeable to the driver. Who is correct?

You are rebuilding a 62TE transmission. You test the overdrive solenoid and find the resistance is 5 ohms. Tech A states that the overdrive solenoid is within specification. Tech B states that the entire solenoid pack will need to be replaced. Who is correct?

The 62TE transmission has seven multidisc clutch packs and ________ to create the necessary gear ratios.

Technician A says that the 62TE transmission needs a special tool to determine the fluid level. Technician B says that an old speedometer cable can be used as a transmission fluid dipstick. Who is correct?

Before installing the low/reverse clutch piston in a 62TE transmission, which component(s) should be replaced?

The rebuild of an underdrive section is being discussed. Technician A says that if the clutch pack clearance is not correct, a clutch friction disc will need to be added or removed from the pack. Technician B says that a rubber-tipped blow gun and dial indicator are used to measure clutch pack clearance.Who is correct?

Tech A states that the additional gear ratios in the 62TE were created by replacing the transfer shaft in the 41TE. Tech B states that 62TE retains the transfer shaft used in the 41TE. Who is correct?

The helical shim on the compounder of a Chrysler 62TE transmission needs to be replaced if the end play of the output carrier is __________.

Identify the transmission fluid level for a fluid temperature of 138 degree Fahrenheit.

Technician A says that the 62TE transmission needs a special tool to determine the fluid level. Technician B says that an old speedometer cable can be used as a transmission fluid dipstick. Who is correct?