Exam 24: Chrysler 6 Speed 62te Transmission

A vehicle comes in with no reverse. Tech A states that the vehicle could have a problem with the reverse clutch. Tech B states that the vehicle could have a problem with the low clutch. Who is correct?

You are rebuilding a 62TE transmission. You measure the input shaft end play and find that the end play is 0.032 inches (0.81 mm). The thrust plate in the transmission is a 0.053 inches (1.34 mm). Which thrust plate would you select to correct the problem?

You have a vehicle come in with a complaint of harsh shifting. You measure line pressure and find that it is high. You look at the scan tool and find that the pressure control solenoid is commanded to 62%. Tech A states that the TCM is commanding the transmission to maximum line pressure. Tech B states that the TCM is commanding 62% of line pressure. Who is correct?

Double swap shift means that when the transmission shifts from second gear to third gear, ________.

All of the following statements with respect to the fourth prime ratio are true except:

The overrunning sprag of 62TE is held at all of the following except:

Tech A states that a double swap shift would take a considerably longer amount of time to complete. Tech B states that a double swap shift would be noticeable to the driver. Who is correct?

The 62TE transmission has seven multidisc clutch packs and ________ to create the necessary gear ratios.

Identify the transmission fluid level for a fluid temperature of 77 degree Fahrenheit.

Two technicians are discussing the 62TE transmission. Tech A states that the 6 speed transmission has 7 forward gear ratios and 1 reverse ratio. Tech B states that the transmission has 6 forward gear ratios and 1 reverse ratio. Who is correct?

Identify the type of transmission fluid that is required by 62TE.

Which of the following clutches are normally applied to allow for the fail safe/limp-in gear in the 62TE transmission?

The 62TE is a ________ front-wheel drive transmission.

A customer brings their vehicle into the shop complaining about poor performance. You test drive the vehicle and find that the transmission is only operating in 3rd gear. Tech A states that this could be cause by a bad 2/4 clutch. Tech B says this could be caused by the TCM not having power. Who is correct?

A vehicle comes into the shop with a customer complaint of transmission performance problems and the MIL is illuminated. You drive the vehicle and determine that the transmission does not have 1st, 3rd or 4th gear. You scan the vehicle and find codes related to ratio errors for 1st, 3rd, and 4th gear. Tech A states that the problem could be the low clutch. Tech B states that the problem could be the sprag. Who is correct?

Double swap shifts occur on all of the following shifts except:

An old speedometer cable is used to check the transmission fluid level of 62TE. Tech A states that the bottom of the cable should be marked at 20 and 30 mm. Tech B states that the bottom of the cable should be marked at 40 and 50 mm. Who is correct?

Identify the transmission fluid level for a fluid temperature of 77 degree Fahrenheit.

Double swap shifts occur on all of the following shifts except:

Besides the crankshaft position sensor, the 62TE transmission has speed sensors for the input shaft, transfer speed shaft, and the output shaft.