Exam 10: Designing Cisco Enterprise Networks (ENSLD)

A company is using OSPF between its HQ location and a branch office. HQ is assigned to area 0, and the branch office is assigned to area 1. The company purchases a second branch office, but due to circuit delays to HQ, it decides to connect the new branch office to the existing branch office as a temporary measure. The new branch office is assigned to area 2. Which OSPF configuration enables all three locations to exchange routes?

You have executed the following commands on switchA: What is the result of executing the given commands? (Choose two.)

Which function are fabric intermediate nodes responsible for in an SD-Access Architecture?

Which method will filter routes between EIGRP neighbors within the same autonomous system?

An engineer is working for a large cable TV provider that requires multiple sources streaming video on different channels using multicast with no rendezvous point. Which multicast protocol meets these requirements?

In an SD-WAN architecture, which methods are used to bootstrap a vEdge router?

Which two border nodes are available in the Cisco SD-Access architecture? (Choose two.)

An organization is designing a detailed QoS plan that limits bandwidth to specific rates. Which two parameters are supported be the traffic policing feature? (Choose two.)

What is an advantage of designing an out-of-band network management solution?

Which two steps can be taken to improve convergence in an OSPF network? (Choose two.)

An organization is designing a detailed QoS plan that limits bandwidth to specific rates. Which two parameters are supported by the traffic policing feature? (Choose two.)

An engineer must design a solution to provide backup connectivity between two sites. The engineer plans to use an Internet connection but company policy requires the connection to be encrypted. Additionally, there are several applications that utilize multicast to deliver video streams between the sites. Which technology should the design include?

A customer is discussing QoS requirements with a network consultant. The customer has specified that end-to-end path verification is a requirement. Which QoS solution meets this requirement?

An engineer is tasked with designing a dual BGP peering solution with a service provider. The design must meet these conditions: • The routers will not learn any prefix with a subnet mask greater than /24. • The routers will determine the routes to include in the routing table based on the length of the mask alone. • The routers will make this selection regardless of the service provider configuration. Which solution should the engineer include in the design?

A router running ISIS is showing high CPU and bandwidth utilization. An engineer discovers that the router is configured as L1/L2 and has L1 and L2 neighbors. Which step optimizes the design to address the issue?

In what mode does an LWAPP-enabled access point operate?

When a network is designed using IS-IS protocol, which two circuit types are supported? (Choose two.)

What are two benefits of designing an SD-WAN network fabric with direct Internet access implemented at every site? (Choose two.)

Which command is needed to enable DHCP snooping if a switchport is connected to a DHCP server?

What is the role of a control-plane node in a Cisco SD-Access architecture?