Exam 10: Designing Cisco Enterprise Networks (ENSLD)

Which routes does the overlay management protocol advertise in an SD-WAN overlay?

A company has the following network infrastructure. (Refer to the exhibit.) Router A is a GLBP active virtual gateway with priority level set to 250. Routers B and C are configured with the default GLPB configurations. The configuration of the active virtual gateway needs to be changed such that if the AVG fails, Router C should be elected to be used as an active virtual gateway. As the network administrator, you have been asked to make corresponding changes to the configuration. Which command would you use for this purpose on Router C, and where would the command be configured?

Which three feature sets are used in Stackwise technology? (Choose three.)

An engineer must design a multicast network for a financial application. Most of the multicast sources also receive multicast traffic (many-to-many deployment model). To better scale routing tables, the design must not use source trees. Which multicast protocol satisfies these requirements?

An engineer is upgrading a company's main site to include a connection to a second ISP. The company will receive full Internet routing tables from both ISPs via BGP. The engineer must ensure that the company does not become a transit autonomous system. Which solution should be included in this design?

The implementations group has been using the test bed to do a 'proof-of-concept' that requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After several changes to the network addressing, routing scheme, DHCP services, NTP services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has been opened indicating that Client 1 cannot ping the 209.65.200.241 address. Use the supported commands to isolated the cause of this fault and answer the following questions. The fault condition is related to which technology?

A customer with an IPv4 only network topology wants to enable IPv6 connectivity while preserving the IPv4 topology services. The customer plans to migrate IPv4 services to the IPv6 topology, then decommission the IPv4 topology. Which topology supports these requirements?

An engineer is looking for a standards-driven YANG model to manage a multivendor network environment. Which model must the engineer choose?

Which PIM mode uses a shared tree only?

Which solution allows overlay VNs to communicate with each other in an SD-WAN Architecture?

Which technology provides a multichassis IP connection between VSS-enabled switches and downstream devices?

An engineer is designing an enterprise campus network. The LAN infrastructure consists of switches from multiple vendors, and Spanning Tree must be used as a Layer 2 loop prevention mechanism. All configured VLANs must be grouped in two STP instances. Which standards-based Spanning Tree technology supports this design solution?

Which two BGP features will result in successful route exchanges between eBGP neighbors sharing the same AS number? (Choose two.)

Which control-plane protocol is used to map an endpoint to a location in a Cisco SD-Access network?

Which design consideration should be observed when EIGRP is configured on Data Center switches?

Refer to the exhibit. Area 10 is a regular OSPF area and networks 10.1.1.0/24 and 172.16.1.0/24 are internal. Which design provides optimal routing between both networks when the link between routers C and E fails?

How is redundancy achieved among Cisco vBond Orchestrators in a Cisco SD-WAN deployment?

An engineer must propose a solution for a campus network that includes the capability to create multiple Layer 3 virtual networks. Each network must have its own addressing structure and routing table for data forwarding. The solution must be scalable to support hundreds of virtual networks and allow simple configuration and management with minimal administrative overhead. Which solution does the engineer recommend?

An enterprise customer has these requirements: end-to-end QoS for the business-critical applications and VoIP services based on CoS marking. flexibility to offer services such as IPv6 and multicast without any reliance on the service provider. support for full-mesh connectivity at Layer 2. Which WAN connectivity option meets these requirements?

How is sub-second failure of a transport link detected in a Cisco SD-WAN network?