Exam 5: Hand Tools and Shop Equipment

A dial caliper is accurate to _____ inch.

A UNC bolt with three radial lines (marks) on its head has a tensile strength grade of ____________________.

Technician A torques critical parts using an impact wrench. Technician B torques critical parts with an air ratchet. Who is correct?

Technician A says antiseize compound is used to prevent bolts from seizing in aluminum. Technician B says thread sealant is used to prevent leaks. Who is correct?

Describe the proper usage of a hacksaw.

Technician A says coarse threaded bolts are used where superior holding force is necessary. Technician B says bolts that have rolled threads are 30 percent stronger than bolts with cut threads. Who is correct?

The bolts used to attach an engine sling to the engine must thread into the cylinder head or block _____ times the diameter of the bolt.

What is the best source for vehicle identification?

How are hammers identified?

In an oxyacetylene welding torch the acetylene hose is colored _____.

A telescoping gauge is also called a(n) ____________________ gauge.

Metric and SAE wrenches are interchangeable.

Machine screws can have a(n) _____ head.

One liter equals 61.02 cubic inches.

To prevent vibration from loosening the fasteners, locknuts have _____ inserted into a section of the threads.

Name the parts of a bolt.

A(n) ____________________ gauge is used to measure the number of threads per inch on a bolt.

If the number 8.8 is stamped on the head of a bolt, the bolt is ______.

One liter equals 3.7854 gallons.

A(n) ____________________ press is used to install piston pins, axle bearings, drum and rotor studs.