Exam 5: Hand Tools and Shop Equipment

What type of wrench should be used to loosen or tighten brake lines or tubing fittings?

An extractor is used for removing broken ______.

Which of the following screwdrivers is like a Phillips but has a flatter and blunter tip?

What are some safety issues concerning the use of power tools?

When installing a new hacksaw blade, the teeth should face rearward.

A(n) ____________________ hammer should be used to install gears and shafts in a transmission.

NPT stands for ______.

Turning effort [the amount of torque it takes to maintain rotation of a gear or shaft] can be easily measured using a _____type torque wrench.

A(n) ____________________ wrench has one fixed jaw and one movable jaw.

Which source of information will give you the most detail about a specific system or part?

Combination pliers are often called ____________________ pliers.

Each number on the sleeve of a metric micrometer represents _____ mm.

Technician A says a bolt may break because the fillet is damaged. Technician B says that a bolt may become fatigued and break if it is undertightened. Who is correct?

Identify and describe the purpose of three washer designs used with fasteners.

Technician A removes rivets with a hammer and screwdriver. Technician B removes rivets with a hammer and punch. Who is correct?

One bar equals one pound per square inch.

Bolt length is measured from the top surface of the head to the end of the threads.

Technician A says a vernier caliper can be used to measure the outside diameter of something. Technician B says a vernier caliper can be used to measure the inside diameter of a bore. Who is correct?

A(n) ____________________ extension allows the socket to pivot up to 16 degrees.

Ten inch pounds of torque equals 13.558 Newton (N) meters.