Exam 37: Clutches

Internal slave cylinders are being discussed. Technician A says the slave cylinder and the clutch release bearing are a single unit and cannot be serviced separately. Technician B says to replace the slave cylinder, the transmission must be removed. Who is correct?

Technician A says the clutch fork moves the pilot bearing. Technician B says the clutch fork movement is controlled by the clutch pedal. Who is correct?

The clutch release bearing exerts pressure upon the ______.

The clutch friction disc always rotates with the ______.

Until recently, the material that was molded or woven into facings of the clutch disk was predominantly asbestos.

Clutch drag occurs if the clutch disc is not completely released when the clutch pedal is fully depressed.

What is the difference between chatter, pedal pulsation, and clutch vibration?

When compared to a diaphragm-type pressure plate, a coil spring pressure plate assembly has fewer moving parts.

A whirring, grating, or grinding sound that occurs when the clutch pedal is depressed and stops when the pedal is fully released is most likely caused by ______.

Which of the following components is NOT part of a clutch disc?

The two driving members [inputs] of the clutch assembly are the flywheel and ______.

Passenger cars and light trucks are now almost exclusively equipped with _____ spring-type clutches.

There is approximately 10 psi residual pressure in the hydraulic clutch lines when the clutch is in the engaged position.

What should be done during routine maintenance to einsure that the clutch will perform adequately?

A clutch release bearing is often called a(n) ____________________ bearing.

Which of the following is probably NOT the cause of a vibrating clutch?

____________________ is another name for the diaphragm spring.

Coil spring-type pressure plates require less pedal effort than diaphragm-type pressure plates.

The release bearing slides back and forth on the hollow shaft that is part of the ______.

Technician A checks the flywheel for runout [warpage] using a dial indicator. Technician B uses a straightedge to check the pressure plate for warpage. Who is correct?