Exam 39: Manual Transmissiontransaxle Service

A rough growling noise occurs when the vehicle is moving and the transmission is in forward or reverse gears. The noise is not heard when the transmission is in neutral. Technician A says the output or mainshaft bearings may be faulty. Technician B says the pilot bearing may be faulty. Who is correct?

A growling noise that occurs when the transaxle is in neutral, the vehicle is not moving, the engine is running, and the clutch is engaged is most likely caused by ______.

Technician A loosens the CV joint axle nut using a breaker bar with the wheels on the ground and an assistant holding pressure on the brake pedal. Technician B uses an impact wrench. Who is correct?

Prior to disassembling a manual transmission, measure the input and output shaft ____________________ with a dial indicator.

If a threaded area in an aluminum housing is damaged, a _____ insert can be used to restore the damaged threads.

Technician A checks the transmission mounts by pushing up and down on the transmission while observing the mounts. Technician B says if the case moves up but not down, the mounts require replacement. Who is correct?

Name three lubricant types that are used in manual transmissions.

A clicking noise during transmission/transaxle operation may be an indication of ______.

Manual transmission/transaxle internal shift linkage should be adjusted if a shift linkage problem is identified.

What type of bearings should not be washed in solvent?

Prior to disassembling the transmission/transaxle, clean the unit with a ______.

A poorly adjusted shift linkage can cause which of the following problems?

Some aluminum manual transmission/transaxle case cracks may be repaired with a(n) ____________________ sealer.

Transmission ID numbers are being discussed. Technician A says most identification numbers include the model, gear ratios, manufacturer, and assembly date. Technician B says the transmission ID number is located on the driver's side door pillar. Who is correct?

Technician A checks the condition of blocking rings by measuring the clearance between the blocking ring and the face of the gear. Technician B visually inspects the blocking ring for worn clutch teeth and smooth internal surfaces. Who is correct?

Technician A says spinning bearings with compressed air is a good way to dry them. Technician B says spinning a bearing with air may cause it to be damaged. Who is correct?