Exam 5: Drill Press

____ tool posts and holders have been largely replaced since they do not offer as much rigidity as newer toolholding methods.

____ threads have a helix that causes assembled fasteners to get tight when rotated clockwise.

The ____ is a bar that spans the length of the bed and contains gear teeth.

The ____ directly transmits power to the leadscrew.

____ combines turning and facing to create a step where two different diameters meet.

A belt drive lathe transmits power from the motor to the spindle by means of belts and what is known as a ____.

A(n) ____ is a specially designed plate that is mounted on the spindle nose.

A knurling tool contains ____ hardened steel roll(s) of a desired pattern.

____ is producing a raised pattern on the circumference of a workpiece.

A drawback to the ____ method is that only external tapers can be machined.

With ____ turning, the turning tool must always be set on center just as when facing.

Taper per inch is the ____ change in one inch of length.

FPR stands for ____.

____ is cutting across the end of a workpiece to machine the end flat.

____ threads change in diameter from one end to the other.

The ____ is an H-shaped casting that slides back and forth on the ways.

The ____ of the lathe is determined by the biggest diameter workpiece that can be mounted in the spindle without touching the ways.

When using the tool bit method, taper length can be limited by ____.

Class ____ fits have little or no clearance between mating threads

A(n) ____ tool post consists of a T-nut, clamping stud, and a multi-sided tool block with either removable or integral toolholders.