Exam 5: Drill Press

After the taper attachment setting is verified, set an appropriate ____ speed and feed rate.

Tapers can be specified on prints by ____ basic methods.

The ____ is the thread surface that joins the crest to the root.

Remember to bring the carriage about ____ past the start point before taking a cut to eliminate backlash.

Form ____ is used to produce contoured surfaces on a conventional lathe.

The jaws of ____ chucks advance and retract simultaneously.

Once tailstock ____ is complete, the work can be mounted between centers.

____ may be needed to accept O-rings or retaining rings, act as a relief for threading, or to provide clearance on shoulders for mating parts.

A(n) ____ chuck is a device used to clamp a workpiece in the lathe spindle by applying pressure on multiple sides.

Just under the headstock is another gear train called the quick-change ____.

The ____ is a very long threaded rod supported by bearings at both ends.

A ____ is a lathe accessory that can move the cross slide either in or out as the carriage moves longitudinally along the ways.

A ____ clamps directly to the lathe's ways and acts as a brace to surround and support the workpiece.

____ refers to the distance that the cutting tool is engaged in the workpiece.

On a ____ lathe, a small portion of the lathe bed can be removed to allow larger-diameter workpieces to be machined.

A ____ is a special precision cylindrical shaft that can be inserted through the center bore of the workpiece to secure it for machining.

____ collets are very accurately ground cylindrical sleeves.

The ____ supports the lathe cutting tool and provides the tool with the movement needed to perform machining operations.

Performing a ____ operation on the lathe uses a special narrow tool to take off the end workpiece to a desired length.

The purpose of ____ is to produce a smoother surface and bring the part to the final desired size.