Exam 6: Milling

____ endmills are used to produce a bevel on the workpiece edge.

____ have cutting edges both on their end and on their periphery for milling.

A(n) ____ can be used to very accurately find a reference edge.

A ____ aids in positioning the head at the desired angle.

The ____ cutter is a simple cutting head that holds a single-edged cutting tool.

____ workpieces that require direct clamping usually need to be aligned.

The ____ rests on this surface and allows the entire machine head to be swiveled 360 degrees.

A(n) ____ endmill is a multiple-flute hollow cutter that is mounted onto an arbor.

A ____ mill is a multiple-cutting-edge milling cutter that has replaceable inserted cutting edges.

____ are the most commonly used workholding devices for milling.

The ____ is mostly used for rotating the workpiece to a position and then securing it there for machining.

Milling machine ____ rates are specified in IPM.

Toolholding devices must have a(n) ____ taper in order to be mounted into the machine spindle.

____ milling is using the outside periphery of the cutting tool to machine a surface.

You should offset ____ of the mill table axes to cut a radius.

The ____ permits movement toward and away from the column along the Y-axis.

The ____ endmill is an endmill with a half-round sphere ground on its end.

A ____ is an internal part feature machined into the surface of a workpiece that breaks through at least one edge of it.

A(n) ____ is commonly used to hold the boring bar and provides the ability to offset the bar to control hole size.

____ allows the spindle to be directly rotated by hand and locked with pin or plunger against an indexing plate having the appropriate number of divisions.