Exam 3: Job Planning, Benchwork, and Layout

____ hammers have heads made from tightly rolled and shaped material that offers little rebound.

The ____ is the peak of one thread and creates the points from which the major diameter is measured.

____ pliers have broad, flat jaws and are used for gripping as well as cutting wire and pins.

An object can be cut along an imaginary line by a ____ line to create a special type of view called a section view.

A ____ is a spiral groove made on a round external or internal diameter.

Multiple, identical part features or equal dimensions can also be identified as typical dimensions by adding the abbreviation ____ after a dimension.

____ clamps are useful for light-duty applications such as holding small and delicate parts.

Two main types of starter drill bits are ____ drill and combination drill bits.

To provide a better visualization of the part, a drawing may contain a three-dimensional view called a(n) ____.

____ screwdrivers have a broad, flat tip and are made in many sizes to fit the width and thickness of the screw slot.

The ____ gage is used with a surface plate to measure and mark off horizontal lines in precision layout work.

The relationship between the sizes of two mating parts is called the ____ fit.

____ hammers are made in a variety of sizes based on the weight of the head.

____ lines are thin and are broken into a series of short dashes.

The ____ saw is capable of cutting off large pieces of stock both quickly and accurately, holding tolerances to + or - 0.015 of an inch or better.

____ screwdrivers have a cross-shaped tip that helps prevent slippage and come in sizes 1 to 4.

Countersinking is also frequently performed to create a ____ at the opening of a hole to allow easier entry of pins, aid in starting taps, and for deburring.

A dimension shown on a print is called a ____ size.

A(n) ____ has teeth set in a pattern in which every other tooth switches the side of the blade it is set to.

To finish a part to the final dimension and obtain a better finish, use a ____ filing technique.