Exam 17: Wall Finish

Prefinished ____ is probably the most widely used sheet paneling.

After application of joint compound is completed, a minimum interior temperature of 50 degrees F must be maintained for ____ days.

The typical width of drywall boards is__ feet.

When driving drywall fasteners it is important not to break the paper surface.

For laminating gypsum boards to each other, joint compound adhesives and ____ adhesives are used.

When selecting wood paneling with an emphasis on ____, knotty pine, pecky cypress, and white-pocketed Douglas fir board paneling may be used.

Ceiling joists are sometimes brought into alignment with the installation of a ____ across the tops of the joists near the center of the span.

Paneling of a room should begin and end in the least __________ corner.

____ type compounds harden through a chemical reaction when water is added to the dry powder.

Light tones in wood paneling include birch, maple, spruce, and white pine.

Drywall panels come in thickness that range from 1 / 4 to 1 inch.

To help prevent nail popping and cracking due to structural stresses where walls and ceilings meet, the ____ method of drywall application is used.

Gypsum wallboard is usually installed horizontally, at ____ degree angles to the studs.

A ________ is sometimes used to set corner beads to the proper angle.

Partial paneling that does not extend to the ceiling but covers only the lower portion of the wall is called ____.

Like gypsum board, cement board is a panel product.

Cutouts in wall panels are not cut with power tools.

For vertical application of board paneling in a frame wall, blocking must be provided between studs.

Joint reinforcing tape is used to cover, strengthen, and provide crack resistance to drywall joints.

____ panels have a core of Portland cement reinforced with a glass fiber mesh embedded in both sides.