Exam 20: Cabinets and Countertops

Shimming the base cabinets eliminates the need for a molding.

If the edge of a countertop has a ____ corner, the laminate can be bent.

____ is used for bonding plastic laminates and other thin, flexible material to surfaces.

High quality drawers are made with rabbeted or butt joints.

Standard wall cabinets are ____ inches deep.

____ catches are used to hold one door of a double set and are released by reaching to the back side of the door.

The two basic kinds of kitchen cabinets are the wall unit and the ____ unit.

The leaves of a ____ hinge are set into gains in the edges of the frame and the door, in the same manner as for entrance doors.

Manufactured cabinets are available in widths ranging from 18" to 42".

The prints for a building contain plans, elevations, and details that show the ____ of cabinets.

Strips of laminate can be cold bent to a minimum radius of about ____ inches.

Doors can be classified by their construction as solid or ____.

Laminates are ordinarily used in ____ thicknesses.

____ hinges are applied to the exterior surface of the door and frame.

Cabinets consist of a case that is fitted with shelves, doors, and / or drawers.

Doors without self-closing hinges need ____ to hold them closed.

Tall cabinets are usually manufactured 28 inches deep.

When installing ____ hinges, first screw the hinges on the door.

In a cabinet installation, the drawer type should match the door type.

Pieces of laminated adhered with contact cement may be easily adjusted into position after the glued surfaces touch.