Exam 4: Turning

Feed rates for drill press operations are specified in ____.

____ refers to the movement, or advancement, of the cutting tool into the workpiece, and feed rate is the term used in the shop to describe this.

Morse taper ____ adapters increase the size of a tool's shank taper.

The ____ drill press is the largest of the drilling machines.

A(n) ____ drill press operates at very high spindle speeds and is used to produce very small holes.

A drill press without a power-feed mechanism is sometimes called a ____ drill press because the operator can "feel" the cutting action of the tool and adjust the rate of feed for optimal cutting pressure by increasing or decreasing pressure on the feed handle.

The ____ chuck is a micro drill chuck that has a much slimmer design, has a smaller capacity, and will enable very small drills to run truer than a larger chuck.

The ____ is the angle of a drill's spiral relative to the center axis of the drill.

The ____ of a drill are the angled cutting edges that shear the metal into chips as the drill rotates.

The ____ of a drill bit provides an area for mounting the drill bit into a holder.

The ____ drill press consists of a column mounted at 90 degrees to a base.

Lip clearance is the relief angle from the lips back to the ____.