Chat with AIExam 2: Basic Theoriesspecial Tools and Procedures
Exam 1: Introduction to Automotive Electrical and Electronic Systems Safety90 Questions
Exam 2: Basic Theoriesspecial Tools and Procedures90 Questions
Exam 3: Electrical and Electronic Componentsbasic Electrical Troubleshooting and Service60 Questions
Exam 4: Wiring and Circuit Diagramswiring Repair and Reading Circuit Diagrams60 Questions
Exam 5: Automotive Batteriesbattery Diagnosis and Service60 Questions
Exam 6: Starting Systems and Motor Designsstarting System Diagnosis and Service60 Questions
Exam 7: Charging Systemscharging System Testing and Service61 Questions
Exam 8: Introduction to the Body Computerbody Computer System Diagnosis60 Questions
Exam 9: Computer Inputssensor Diagnostic Routines60 Questions
Exam 10: Vehicle Communication Networksvehicle Multiplexing Diagnostics61 Questions
Exam 11: Lighting Circuitslighting Circuits Repair and Diagnosis65 Questions
Exam 12: Instrumentation and Warning Lampsinstrumentation and Warning Lamp System Diagnosis and Repair60 Questions
Exam 13: Accessorieselectrical Accessories Diagnosis and Repair60 Questions
Exam 14: Radio Frequency and Infotainment Systemsservicing Radio Frequency and Infotainment Systems60 Questions
Exam 15: Passive Restraint and Vehicle Safety Systemsservicing Passive Restraint and Vehicle Safety Systems60 Questions
Exam 16: Vehicles With Alternative Power Sourceshybrid and High-Voltage System Service61 Questions
Select questions type
The figure bel ow represents what type of circuit?
Free
(Short Answer)
4.8/5 
(77)
(77) Correct Answer:
Verified
Verifiedseries
List Kirchhoff's two laws of voltage and current.
Free
(Essay)
4.7/5 (82)
(82) Correct Answer:Verified
VerifiedLaw of voltage states that the algebraic sum of all voltage drops and sources in a closed circuit equal zero-the sum of all voltage drops equal the source voltage.
Law of current states that the algebraic sum of the current entering and leaving a point equals zero. Total current flow in a parallel circuit is the sum of each of its branches currents.
What is the formula for Ohm's Law (in which E = volts, I = amperes, and R = resistance)?
Free
(Multiple Choice)
4.8/5 (77)
(77) Correct Answer:Verified
VerifiedB
The total resistance of all the parallel loads is always more than the smallest individual resistance.
(True/False)
4.9/5 (82)
(82) All of the following concerning the use of jumper wires are true except:
(Multiple Choice)
4.9/5 (76)
(76) Technician A says the total amperage in a parallel circuit is equal to the sum of the individual branch circuits. Technician B says the amperage in a series circuit is the same anywhere in the circuit. Who is correct?
(Multiple Choice)
4.7/5 (73)
(73) Technician A says power is found by multiplying voltage times current. Technician B says power is expressed as wattage. Who is correct?
(Multiple Choice)
4.8/5 (66)
(66) Technician A says that an ammeter should be connected in parallel to the circuit being tested. Technician B says that an ammeter is used to measure current flow. Who is correct?
(Multiple Choice)
4.9/5 (81)
(81) Technician A says that a digital storage oscilloscope is like a very fast reacting volt meter. Technician B says the upward trace on a digital storage oscilloscope screen indicates a specific period of time. Who is correct?
(Multiple Choice)
4.9/5 (77)
(77) Technician A says that a logic probe may be used on computer controlled circuits. Technician B says that a logic probe may be used on a low voltage pulsed signal. Who is correct?
(Multiple Choice)
4.8/5 (87)
(87) Technician A says testing with a voltmeter can determine the voltage drop across the headlights. Technician B says a voltmeter can determine if excessive resistance is in the circuit. Who is correct?
(Multiple Choice)
4.9/5 (70)
(70) 
In a series circuit which of the following statements is correct?
(Multiple Choice)
4.9/5 (87)
(87) 
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)