Question 1

To meet specific business requirements, QoS-marked traffic must be sent over a dedicated link. Which technology fulfills this requirement?

Accepted Answer

A)  MPLS 
B)  Q-in-Q tunneling 
C)  policy-based routing 
D)  EIGRP with modified metrics

Question 2

Refer to the exhibit.  A service provider would like to use Ethernet OAM to detect end-to-end connectivity failures between SP-SW1 and SP-SW2. In which two of these ways can you design this solution? (Choose two.)

Accepted Answer

A)  Enable Y.1731 Connectivity Fault Management on the SP switches. 
B)  E-LMI PDUs must be forwarded over VPLS. 
C)  Cisco Discovery Protocol PDUs must be forwarded over the VPLS. 
D)  Use upward maintenance endpoints on the SP switches. 
E)  Enable IEEE 802.1ag Connectivity Fault Management on the SP switches.

Question 3

Study the exhibit carefully. Configure P4S-R1, P4S-R2, and P4S-R3 to run EIGRP on all their connected interfaces. P4S-R2 is also configured as an EIGRP stub. Which EIGRP routes are in the local topology table at P4S-R3?

Accepted Answer

A)  172.30.2.0/24, 172.30.3.0/31 and 172.30.3.2/31 
B)  172.30.0.0/16 
C)  There's not enough information provided to know what would be in the topology table at P4S-R3. 
D)  172.30.1.0/24, 172.30.2.0/24, 172.30.3.0/31 and 172.30.3.2/31

Question 4

Which security benefit can be provided by IPv4 anycast for a service such as DNS?

Accepted Answer

A)  robust detection capabilities 
B)  multiple paths to the service 
C)  improved availability of services during DoS attacks 
D)  mitigation of attacks

Question 5

You work as a network administrator for the P4S company. You are responsible for a large-scale EIGRP network and you have discovered that one hub-and-spoke topology in the network is generating a lot of link flaps. You have tried many times to reduce the number of link flaps, but it seems that the stability of the hub-and-spoke topology can not be improved. The reason for this is that most failures seem to result from power outages in a number of locations. Which action should you take?

Accepted Answer

A)  demand that uninterruptible power supplies be installed at every point in the network to prevent future outages 
B)  summarize the routes advertised into the core of the network to reduce the impact of these frequent failures 
C)  switch routing protocols to IS-IS, which handles large neighbor counts better and supports Partial SPF by default 
D)  switch routing protocols to OSPF, then create area boundaries to reduce the size of fault domains

Question 6

Refer to the exhibit.  This diagram depicts the design of a small network that will run EIGRP on R1 and R2, and EIGRP Stub on R3. In which two ways will this network be impacted if there is link instability between R1 and R2? (Choose two.)

Accepted Answer

A)  R1 will have routes in its routing table that originate from R2 and R3. 
B)  R3 will have routes in its routing table that originate from R1 and R2. 
C)  R2 will have routes in its routing table that originate from R1 and R3. 
D)  R3 will be transit for traffic between R1 and R2. 
E)  R3 will not be transit for traffic between R1 and R2.

Question 7

Which three components comprise the AVVID framework? (Choose three.)

Accepted Answer

A)  common network infrastructure 
B)  abstracted integration 
C)  network solutions 
D)  intelligent network services

Question 8

You are redesigning an OSPF v2 network and must migrate some links. You are concerned that there are different subnet masks. Which two link types will still form an OSPF adjacency even if there are subnet mask mismatches? (Choose two.)

Accepted Answer

A)  virtual 
B)  broadcast 
C)  point-to-multipoint 
D)  non-broadcast 
E)  point-to-point

Question 9

To securely transport EIGRP traffic, a network administrator will build VPNs between sites. What is the best method to accomplish the transport of EIGRP traffic?

Accepted Answer

A)  IPSec in tunnel mode 
B)  IPSec in transport mode 
C)  GRE with IPSec in transport mode 
D)  GRE with IPSec in tunnel mode

Question 10

You have been tasked to create a Layer 2 network design that uses vPC to provide resiliency and avoid loops. vPC removes Layer 2 loops while providing redundancy through which mechanism? "Pass Any Exam. Any Time." - www.actualtests.com 47 Cisco 352-001 Exam

Accepted Answer

A)  dual-active detection 
B)  address synchronization 
C)  strict forwarding rules 
D)  Bridge Assurance

Question 11

In a DMVPN network with next-hop servers, which two configurations provide redundancy? (Choose two.)

Accepted Answer

A)  one tunnel interface configured to run over two DMVPN clouds 
B)  two DMVPN clouds configured with one tunnel interface each 
C)  two DMVPN clouds configured with two next-hop servers using anycast addresses 
D)  two next-hop servers configured to use a single tunnel interface within one DMVPN cloud

Question 12

You are designing an OSPF network with multiple areas for a large client. Due to the size of the routing domain, all areas except the backbone area are configured as stub areas. A new requirement is to connect a WAN link to a partner organization with a static route to stub area 100. What should you do to redesign area 100, if anything, in order to support this WAN link while minimizing the size of the link state database?

Accepted Answer

A)  Convert area 100 into an NSSA 
B)  No configuration changes to area 100 are needed 
C)  Convert area 100 into a normal area. 
D)  Redistribute the staticroute as OSPF type E1.

Question 13

Today most of the enterprises are selecting container technologies that require integration with their existing data centers and infrastructure solutions. With which three factors do enterprises most commonly struggle to enable their current IT operations staff with? (Choose three.)

Accepted Answer

A)  compliance 
B)  data security 
C)  performance and availability 
D)  cost avoidance 
E)  virtualization
F) data analytics
G) scalability

Question 14

Which two components are the responsibility of the customers in a Platform as a Service offering? (Choose two.)

Accepted Answer

A)  applications 
B)  infrastructure connectivity 
C)  hardware 
D)  data 
E)  APIs

Question 15

An MPLS service provider is offering a standard EoMPLS-based VPLS service to Customer A, providing Layer 2 connectivity between a central site and approximately 100 remote sites. Customer A wants to use the VPLS network to carry its internal multicast video feeds, which are sourced at the central site and consist of 20 groups at 5 Mb/s each. Which service provider recommendation is the most scalable?

Accepted Answer

A)  EoMPLS-based VPLS already carries multicast traffic in a scalable manner. 
B)  Replicate the multicast traffic on the P routers. 
C)  Replace VPLS with a Layer 3 MVPN solution to carry the streams between sites. 
D)  Use GRE tunnels to carry the streams between sites.

Question 16

Flex Links are a pair of a Layer 2 interfaces (switchports or port channels), where one interface is configured to act as a backup to the other. Which two statements are correct regarding Flex Links?

Accepted Answer

A)  An interface can only belong to single Flex Links. 
B)  An interface can belong to multiple Flex Links. 
C)  Flex Links operate only over single pairs of links. 
D)  Flex Links automatically disable STP so no BPDUs are propagated.

Question 17

Which three types of LSA could each trigger a partial SPF? (Choose three.)

Accepted Answer

A)  type 2 LSA (Network Link Advertisements) 
B)  type 3 LSA (ABR Summary Link Advertisements) 
C)  type 4 LSA (ASBR Summary Link Advertisements) 
D)  type 5 LSA (Autonomous System External Link Advertisements)

Question 18

While planning network availability, which two factors should be taken into consideration? (Choose two.)

Accepted Answer

A)  mean time before failure 
B)  mean time to discover the failure 
C)  mean time to notification 
D)  mean time to repair

Question 19

You are the Cisco Network Designer in P4S. Which two settings must be configured in order to use the GUI to configure Call Admission Control with voice applications? (Choose two.)

Accepted Answer

A)  QoS must be set to Silver 
B)  WMM must be enabled 
C)  QoS must be set to Gold 
D)  QoS must be set to Platinum

Question 20

The P4S company connects a pair of sites with three GigE links between two routers with fairly high processor utilization. It has a great many pairs of hosts communicating between the sites, and some use applications that may be sensitive to packet re-ordering. How to maximize the utility of the links while adding minimal load to the routers?

Accepted Answer

A)  use policy-based routing to force all delivery order applications onto a single link and configure per-packet load sharing across the remaining two links 
B)  verify that the total delay of each link is within 100 milliseconds of the other two links and configure per-packet load sharing across the three links 
C)  set the link metrics so all three paths are installed in the routing table and use the default per-flow load sharing across the links 
D)  use multilink PPP to bundle the three links into a single logical link and adjust the routing metrics as needed

Exam 44: Deploying Cisco Unified Contact Center Express