Exam 20: Electric Circuits
Exam 11: Fluids65 Questions
Exam 13: The Transfer of Heat42 Questions
Exam 14: The Ideal Gas Law and Kinetic Theory55 Questions
Exam 15: Thermodynamics79 Questions
Exam 17: The Principle of Linear Superposition and Interference Phenomena51 Questions
Exam 20: Electric Circuits100 Questions
Exam 22: Electromagnetic Induction71 Questions
Exam 25: The Refl Ection of Light: Mirrors43 Questions
Exam 26: The Refraction of Light: Lenses and Optical Instruments102 Questions
Exam 29: Particles and Waves54 Questions
Select questions type
A lamp uses an average power of 55 W when it is connected to an rms voltage of 120 V.Which entry in the following table is correct for this circuit?

(Short Answer)
4.8/5
(96)
A 10.0-µF capacitor is charged so that the potential difference between its plates is 10.0 V.
A 5.0-µF capacitor is similarly charged so that the potential difference between its plates is 5.0 V.
The two charged capacitors are then connected to each other in parallel with positive plate connected to positive plate and negative plate connected to negative plate.
-What is the final potential difference across the plates of the capacitors when they are connected in parallel?
(Multiple Choice)
4.8/5
(80)
What is the total power dissipated in the two resistors in the circuit shown? 
(Multiple Choice)
4.9/5
(83)
Three resistors and two batteries are connected as shown in the circuit diagram.What is the magnitude of the current through the 12-V battery? 
(Multiple Choice)
4.9/5
(79)
A 4-A current is maintained in a simple circuit with a total resistance of 2
.How much energy is delivered in forty five seconds?
(Multiple Choice)
4.9/5
(68)
Five resistors are connected as shown.What is the equivalent resistance between points A and B? 
(Multiple Choice)
4.9/5
(75)
Three resistors are placed in a circuit as shown.The potential difference between points A and B is 30 V.
-What is the equivalent resistance between the points A and B?
(Multiple Choice)
4.8/5
(80)
The figure shows a simple RC circuit consisting of a 100.0-V battery in series with a 10.0-µF capacitor and a resistor.Initially,the switch S is open and the capacitor is uncharged.Two seconds after the switch is closed,the voltage across the resistor is 37 V.
-Determine the numerical value of the resistance R.
(Multiple Choice)
5.0/5
(79)
How much energy is stored in the combination of capacitors shown? 
(Multiple Choice)
4.9/5
(75)
Which one of the following statements concerning resistors in series is true?
(Multiple Choice)
4.9/5
(77)
Three resistors and two 10.0-V batteries are arranged as shown in the circuit diagram.Which one of the following entries in the table is correct?

(Short Answer)
4.9/5
(98)
Five resistors are connected as shown in the diagram.The potential difference between points A and B is 15 V.
-What is the current in the 2.7-
resistor?
(Multiple Choice)
4.8/5
(81)
Complete the following statement: The electromotive force is
(Multiple Choice)
4.7/5
(75)
The figure shows a circuit.The switch S can be closed on either point A or C,but not both at the same time.Use the following quantities:
V₁ = V₂ = 12 V
R₁ = R₄ = 1.0 W
R₂ = R₃ = 2.0 W
-At what rate is energy dissipated by R₁ when the switch S is closed on A?
(Multiple Choice)
4.9/5
(82)
Which one of the following quantities can be converted to kilowatt - hours (kWh)?
(Multiple Choice)
4.9/5
(95)
An RC circuit consists of a resistor with resistance 1.0 k
,a 120-V battery,and two capacitors,C₁ and C₂,with capacitances of 20.0 µF and 60.0 µF,respectively.Initially,the capacitors are uncharged;and the switch is closed at t = 0 s.
-Determine the total charge on both capacitors two time constants after the switch is closed.
(Multiple Choice)
4.8/5
(74)
The figure shows variation of the current through the heating element with time in an iron when it is plugged into a standard 120 V,60 Hz outlet.
-What is the resistance of the iron?
(Multiple Choice)
4.9/5
(77)
Which one of the following statements concerning capacitors of unequal capacitance connected in series is true?
(Multiple Choice)
4.7/5
(88)
A physics student performed an experiment in which the potential difference V between the ends of a long straight wire was varied.The current I in the wire was measured at each value of the potential difference with an ammeter and the results of the experiment are shown in the table.
Which one of the following statements is the best conclusion based on the data?
(Multiple Choice)
4.9/5
(76)
Determine the length of a copper wire that has a resistance of 0.172
and cross-sectional area of 7.85 × 10-⁵ m².The resistivity of copper is 1.72 × 10-⁸ 11ec9df8_b514_280c_8d20_295ba371075e_TB6393_11 × m.
(Multiple Choice)
4.8/5
(76)
Showing 61 - 80 of 100
Filters
- Essay(0)
- Multiple Choice(0)
- Short Answer(0)
- True False(0)
- Matching(0)