Exam 37: Introduction to Geometric Dimensioning and Tolerancing

In a feature control frame, the compartment on the extreme left contains ____.

When manufactured, the actual size of a feature must be close to the size limits specified on the drawing.

The geometric characteristic symbol for angularity is ____.

Geometric tolerances are required for every feature of a part.

The geometric characteristic symbol for position is ____.

A technical drawing must indicate the permissible variation of size and form.

The symbol stands for ____________________.

Squareness, roundness, and flatness are characteristics of ____________________ on a technical drawing.

Points have position but no size and therefore cannot be measured or dimensioned.

A geometric tolerance is the maximum permissible variation of form, orientation, or ____ of a feature from that indicated or specified on a drawing.

Maximum material condition involves the smallest hole size along with the ____________________ shaft size.

The geometric characteristic symbol for symmetry is ____.

Geometric tolerancing controls geometric characteristics of parts such as circularity, runout, position, etc.

An accurate and useful technical drawing must fully describe the shape of the part, the size of the part, and the ___________________________________.

A geometric tolerance is used to state functional or ______________________________ requirements of a part.