Exam 9: Chamfers, Undercuts, Tapers, and Knurls

A conical taper is used in the manufacture of ____.

Flat tapers are often used in making ____________________.

The taper can be defined in terms of a taper ratio, or in terms of a taper ____________________.

Knurling increases ____________________.

Chamfering is ____.

Creating an undercut is ____.

A flat taper is used in the manufacture of ____.

It is acceptable to omit undercut dimensions if the dimensions are unimportant.

The purpose of a knurled finish is to increase protection from rust.

An undercut is specified using the diameter of the material before it is cut.

A taper ratio of 2:1 means the diameter at one end is half that at the other end.