Exam 6: Starting Systems and Motor Designs Starting System Diagnosis and Service

Which of the following represents the correct sequence of steps that may need to be performed when testing a starting system?

What should be done first to the system when a 0.9 volt drop is observed between the battery positive terminal and the starter solenoid with the engine cranking?

During a starter current draw test, the voltage is 10.2 volts and amperage is above specifications. This could be caused by all of the following EXCEPT:

The gear reduction starter uses:

The starting safety switch is also called a

The armature:

A 600-millivolt drop is measured across the starter motor solenoid while the engine is being cranked. What is the repair?

The characteristic of the series-wound motor is:

The field coils:

Typical components of the control circuit of the starting system include:

Which of the following describes the operation of the starter solenoid?

When there is no current draw and the starter does not rotate, the cause could be

A characteristic of permanent magnet starters is:

The overrunning clutch protects the armature from:

Which of the following statements is true of starter solenoids?

What is the purpose of the commutator?

All of the following could prevent a starter solenoid from operating, EXCEPT:

The overrunning clutch accomplishes which of the following?