Question 1

All of the following are characteristics of the occupant classification system EXCEPT:

Accepted Answer

A) The OCM is responsible for the deployment of the passenger-side air bag. 
B) The system is designed to determine if a rear-facing infant seat is being used in the front passenger seat. 
C) The PADL illuminates whenever the passenger seat is occupied and the passenger-side air bag is suppressed. 
D) Weight classification of fifth percentile female and greater allows air bag deployment. 
A) The OCM is responsible for the deployment of the passenger-side air bag. 
B) The system is designed to determine if a rear-facing infant seat is being used in the front passenger seat. 
C) The PADL illuminates whenever the passenger seat is occupied and the passenger-side air bag is suppressed. 
D) Weight classification of fifth percentile female and greater allows air bag deployment. A

Question 2

The arrow on an air bag sensor must always face the

Accepted Answer

A)  Location of the air bag module 
B)  Rear of the vehicle 
C)  Driver's side of the vehicle 
D) Front of the vehicle 
A)  Location of the air bag module 
B)  Rear of the vehicle 
C)  Driver's side of the vehicle 
D) Front of the vehicle D

Question 3

All of the following are components of the air bag module EXCEPT the

Accepted Answer

A)  Squib 
B)  Coil assembly 
C)  Explosive charge 
D) Bag assembly 
A)  Squib 
B)  Coil assembly 
C)  Explosive charge 
D) Bag assembly B

Question 4

When servicing an air bag system after a deployment all:

Accepted Answer

A)  Components must be replaced 
B)  Sensors must be replaced 
C)  Components must be inspected 
D) Clocksprings must be replaced 
A)  Components must be replaced 
B)  Sensors must be replaced 
C)  Components must be inspected 
D) Clocksprings must be replaced

Question 5

The occupant classification system must be validated whenever:

Accepted Answer

A)  The seat has been removed from the vehicle. 
B) The OCM has been replaced. 
C)  A new sensor has been installed. 
D) All of these choices. 
A)  The seat has been removed from the vehicle. 
B) The OCM has been replaced. 
C)  A new sensor has been installed. 
D) All of these choices.

Question 6

Which of the following is a characteristic of the strain gauge-type occupant classification system?

Accepted Answer

A)  If the seat is empty, the PADL is illuminated. 
B) The system uses a belt tension sensor to determine the presence of an infant seat. 
C)  The air bag will deploy if a child is determined to be sitting in the seat. 
D) None of these choices. 
A)  If the seat is empty, the PADL is illuminated. 
B) The system uses a belt tension sensor to determine the presence of an infant seat. 
C)  The air bag will deploy if a child is determined to be sitting in the seat. 
D) None of these choices.

Question 7

The bladder system service kit is required if any of the following requires replacement EXCEPT:

Accepted Answer

A)  The bladder. 
B) The BTS. 
C)  The pressure sensor. 
D) The cushion. 
A)  The bladder. 
B) The BTS. 
C)  The pressure sensor. 
D) The cushion.

Question 8

The PADL is off when the seat is empty. This may indicate:

Accepted Answer

A)  A faulty OCM. 
B)  Normal operation. 
C)  The BTS is indicating the seat belt is cinched. 
D) All of these choices. 
A)  A faulty OCM. 
B)  Normal operation. 
C)  The BTS is indicating the seat belt is cinched. 
D) All of these choices.

Question 9

All of the following are common sensor types EXCEPT:

Accepted Answer

A)  Mass type 
B)  Roller type 
C)  Hall-effect type 
D) Accelerometer 
A)  Mass type 
B)  Roller type 
C)  Hall-effect type 
D) Accelerometer

Question 10

The purpose of the Occupant Restraint Controller (ORC) is to:

Accepted Answer

A)  Supply back-up power to the system. 
B)  Determine if there is a fault in the system. 
C)  Monitor the system. 
D) All of these choices. 
A)  Supply back-up power to the system. 
B)  Determine if there is a fault in the system. 
C)  Monitor the system. 
D) All of these choices.

All of the following are characteristics of the occupant classification system EXCEPT:

The arrow on an air bag sensor must always face the

All of the following are components of the air bag module EXCEPT the

When servicing an air bag system after a deployment all:

The occupant classification system must be validated whenever:

Which of the following is a characteristic of the strain gauge-type occupant classification system?

The bladder system service kit is required if any of the following requires replacement EXCEPT:

The PADL is off when the seat is empty. This may indicate:

All of the following are common sensor types EXCEPT:

The purpose of the Occupant Restraint Controller (ORC) is to:

Introduction to Automotive Electrical and Electronic Systems Safety

Basic Theories Special Tools and Procedures

Electrical and Electronic Components Basic Electrical Troubleshooting and Service

Wiring and Circuit Diagrams Wiring Repair and Reading Circuit Diagrams

Automotive Batteries Battery Diagnosis and Service

Starting Systems and Motor Designs Starting System Diagnosis and Service

Charging Systems Charging System Testing and Service

Lighting Circuits Lighting Circuits Repair and Diagnosis

Introduction to the Body Computer Body Computer System Diagnosis

Computer Input Sensor Diagnostic Routines

Vehicle Communication Networks Vehicle Multiplexing Diagnostics

Advanced Lighting Circuits Advanced Lighting Systems Diagnosis and Service

Instrumentation and Warning Lamps and Warning Lamp System Diagnosis and Repair

Accessories Electrical Accessories Diagnosis and Repair

Radio Frequency and Infotainment Systems Servicing Radio Frequency and Infotainment Systems

Vehicles With Alternative Power Sources Hybrid and High-Voltage System Service

Filters

Exam 16: Passive Restraint Systems Servicing Passive Restraint Systems

All of the following are characteristics of the occupant classification system EXCEPT:

The arrow on an air bag sensor must always face the

All of the following are components of the air bag module EXCEPT the

When servicing an air bag system after a deployment all:

The occupant classification system must be validated whenever:

Which of the following is a characteristic of the strain gauge-type occupant classification system?

The bladder system service kit is required if any of the following requires replacement EXCEPT:

The PADL is off when the seat is empty. This may indicate:

All of the following are common sensor types EXCEPT:

The purpose of the Occupant Restraint Controller (ORC) is to:

Introduction to Automotive Electrical and Electronic Systems Safety

Basic Theories Special Tools and Procedures

Electrical and Electronic Components Basic Electrical Troubleshooting and Service

Wiring and Circuit Diagrams Wiring Repair and Reading Circuit Diagrams

Automotive Batteries Battery Diagnosis and Service

Starting Systems and Motor Designs Starting System Diagnosis and Service

Charging Systems Charging System Testing and Service

Lighting Circuits Lighting Circuits Repair and Diagnosis

Introduction to the Body Computer Body Computer System Diagnosis

Computer Input Sensor Diagnostic Routines

Vehicle Communication Networks Vehicle Multiplexing Diagnostics

Advanced Lighting Circuits Advanced Lighting Systems Diagnosis and Service

Instrumentation and Warning Lamps and Warning Lamp System Diagnosis and Repair

Accessories Electrical Accessories Diagnosis and Repair

Radio Frequency and Infotainment Systems Servicing Radio Frequency and Infotainment Systems

Vehicles With Alternative Power Sources Hybrid and High-Voltage System Service

Filters