Question 1

MATCHING
Match each item with a statement below:
a.PCIe
f.switch
b.FireWire
g.cut-through mode
c.CardBus
h.store-and-forward mode
d.repeater
i.loopback adapter
e.bridge
-External peripheral device specifying 32-bit interface running at 33 MHz.

Accepted Answer

The answer of MATCHING
Match each item with a statement below:
a.PCIe
f.switch
b.FireWire
g.cut-through...

Question 2

A(n)____ is the circuit board wire over which a device issues voltage to signal this request.

Accepted Answer

A)  interrupt 
B)  IRQ 
C)  IRQ number 
D)  RX

Question 3

By far,the most popular expansion board NIC is one that uses a(n)____ bus.

Accepted Answer

A)  onboard 
B)  PCI 
C)  ExpressCard 
D)  ISA

Question 4

A router that directs data between nodes on an autonomous LAN (or one owned and operated by a single organization)is known as a(n)____________________ router.

Accepted Answer

The answer of A router that directs data between nodes...

Question 5

MATCHING
Match each item with a statement below:
a.PCIe
f.switch
b.FireWire
g.cut-through mode
c.CardBus
h.store-and-forward mode
d.repeater
i.loopback adapter
e.bridge
-Connectivity device that subdivides a network into smaller logical pieces.

Accepted Answer

The answer of MATCHING
Match each item with a statement below:
a.PCIe
f.switch
b.FireWire
g.cut-through...

Question 6

____ are combinations of networking hardware and software that connect two dissimilar kinds of networks.

Accepted Answer

A)  Routers 
B)  Switches 
C)  Gateways 
D)  Broadcast domains

Question 7

The primary difference between the two USB standards is ____.

Accepted Answer

A)  connector pin organization 
B)  security limitations 
C)  speed 
D)  transceiver placement

Question 8

Each time a computer starts up,the device drivers for all its connected peripherals are loaded into ____.

Accepted Answer

A)  ROM 
B)  EEPROM 
C)  RAM 
D)  CMOS

Question 9

If the ____ NIC LED indicator is blinking,the NIC is functioning and receiving frames.

Accepted Answer

A)  LNK 
B)  ACT 
C)  TX 
D)  RX

Question 10

A ____ is a repeater with more than one output port.

Accepted Answer

A)  bridge 
B)  switch 
C)  hub 
D)  router

Exam 6: Network Hardware

MATCHING Match each item with a statement below: a.PCIe f.switch b.FireWire g.cut-through mode c.CardBus h.store-and-forward mode d.repeater i.loopback adapter e.bridge -External peripheral device specifying 32-bit interface running at 33 MHz.

A(n) ____ is the circuit board wire over which a device issues voltage to signal this request.

By far,the most popular expansion board NIC is one that uses a(n) ____ bus.