Question 1

Technician A says one wrench is sufficient when loosening a flare-nut. Technician B says embossed steel gaskets should be installed with the embossed side toward the block. Who is right?

Accepted Answer

A) Technician A 
B) Technician B 
C) Both technicians 
D) Neither technician

Question 2

Drill bits for iron and steel are properly ground to a _____ degree angle.

Accepted Answer

The answer of Drill bits for iron and steel are...

Question 3

During warranty repairs for rear main seal oil leaks, some manufacturers use ____ rear main oil seals.

Accepted Answer

The answer of During warranty repairs for rear main seal...

Question 4

Silicone sealant that does not use acetic acid to cure and is used with oxygen sensor systems is called low _____ RTV.

Accepted Answer

The answer of Silicone sealant that does not use acetic...

Question 5

Technician A says the click-type torque wrench is best because it is the most accurate. Technician B says that an inch-pound torque wrench should be used when measuring smaller torque values. Who is correct?

Accepted Answer