Exam 12: Mist AI, Specialist

Click the Exhibit button. You have configured MSTP in your Layer 2 network. You are having problems with it establishing correctly. Referring to the exhibit, what is causing the problem?

Click the Exhibit button. You recently implemented the configuration shown in the exhibit. After committing these changes, the community devices connected to AS-1 are not able to communicate with the appropriate community devices connected to AS-2. What must be done to allow these community devices to communicate?

Which two statements are true regarding bidirectional PIM? (Choose two.)

You are currently using VLAN IDs 2 through 300 within your Layer 2 domain and you need to configure VSTP to prevent loops. You must ensure that all VLANs are loop free. In this scenario, which statement is correct?

You must ensure that all management traffic sourced from your Junos devices is set with a specific DSCP code-point value. Which action will accomplish this task?

Click the Exhibit button. You are investigating reports of increased latency and discover that some routes cause customer traffic to traverse a route reflector instead of the optimal path. Referring to the exhibit, which configuration statement would solve the problem?

You have an IPv4 multicast network configured as PIM-SM. What must be done before replacing your static RP with auto-RP?

Click the Exhibit button. You have configured and applied the policer shown in the exhibit to your Junos device. Which statement is true in this scenario?

Which protocol is used for port-level access control and authentication?

You have an IPv4 multicast network configured as PIM-SM. What must be done before replacing your static RP with auto-RP?

You are deploying PIM source-specific multicast (SSM) for a new multicast messaging service. You have configured the multicast source to use 235.44.123.100 as the multicast address. You are not able to join the PIM SSM multicast feed. Which two solutions would resolve this problem? (Choose two.)

Click the Exhibit button. You are troubleshooting a route problem in the topology shown in the exhibit. The 10.30.0.0/24 route is not reachable from the R3 router. What would cause this problem?

You want to view the VLANs that have been created dynamically using MVRP. Which operational mode command will display this information?