Exam 28: Geometric Tolerances - Location and Form

Parallelism can be applied to a surface or an axis.

____________ tolerances control the shape of arcs, part contour, or other irregular surfaces.

If neither MMC or LMC is specified:

Position tolerances always require a reference to one or more datums.

The ____________ material condition for a part exists when a hole is at its lowest limit of size, or when a shaft is at its highest limit of size.

Form tolerances require a reference to a datum.

____________ affect the amount of tolerance if the actual size of a feature differs from the MMC or LMC that is specified.

A tolerance zone defined by two flat planes, between which a surface must fall, applies to:

The ____________ material condition for a part exists when a feature contains the minimum amount of material.

The tolerance zone for perpendicularity:

____________ appear in the same box as, and to the right of a tolerance.

Orientation tolerances include:

Two types of location tolerance are:

Form tolerances include:

When concentricity is specified: