Multiple Choice
In order to prime a typical fuel sub-system with a hand-primer pump that has to be installed into the circuit, where should it ideally be located?
A) close to the pick-up tube
B) upstream from the primary filter
C) upstream from the transfer pump
D) downstream from the secondary filter
Correct Answer:
Verified
Correct Answer:
Verified
Q27: When a single pick-up tube is used
Q28: What pumping principle is used by hand-actuated
Q29: When you are asked to repair weld
Q30: What do Caterpillar define as the maximum
Q31: In conditions of extreme heat in most
Q33: When comparing the properties of diesel fuel
Q34: ?Technician A says that some diesel post-2007
Q35: Which of the following is the critical
Q36: When testing for fuel subsystem inlet restriction
Q37: Technician A says that diesel fuel is