Multiple Choice
Tech A says that a feeler gauge is used to measure the diameter of small holes. Tech B says that a feeler gauge and straight edge are used to check surfaces for warpage. Who is correct?
A) Tech A
B) Tech B
C) Both A and B
D) Neither A nor B
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q197: When selecting rivets to suit the job,
Q198: Never take measurements from the very end
Q199: All of the following are important things
Q200: Always store vernier calipers in a storage
Q201: All-wheel drive transfer cases on front-wheel-drive vehicles
Q203: If you want to measure an unknown
Q204: Which of the following is part of
Q205: Which of the following is NOT a
Q206: If a screw is dropped into a
Q207: When using a puller, tighten the forcing