Solved

To Enable Router a to Communicate with Loopback 0 on Router

Question 26

Multiple Choice

To enable Router A to communicate with loopback 0 on Router B on the network shown in the figure, which of the following commands needs to be run on Router A? To enable Router A to communicate with loopback 0 on Router B on the network shown in the figure, which of the following commands needs to be run on Router A? A) ip route-static 10.2.2 32 GigabitEthernet 0/0/0 B) ip route-static 10.2.2 0 GigabitEthernet 0/0/0 C) ip route-static 10.0.2.2 255.255.255.255 10.0.12.2 D) ip route-static 10.0.2.2 255.255.255.255 10.0.12.1


A) ip route-static 10.2.2 32 GigabitEthernet 0/0/0
B) ip route-static 10.2.2 0 GigabitEthernet 0/0/0
C) ip route-static 10.0.2.2 255.255.255.255 10.0.12.2
D) ip route-static 10.0.2.2 255.255.255.255 10.0.12.1

Correct Answer:

verifed

Verified

Unlock this answer now
Get Access to more Verified Answers free of charge

Related Questions

Q21: Two routers are connected via serial interfaces

Q22: An AR2200 router is required to be

Q23: The network administrator attempts to add interface

Q24: Refer to the graphic. <img src="https://d2lvgg3v3hfg70.cloudfront.net/C1485/.jpg" alt="Refer

Q25: What is the neighbor state when an

Q27: What three kinds of display formats of

Q28: Refer to the graphic. IPsec VPN uses

Q29: Refer to the command output. Which statement

Q30: An Ethernet frame is captured by wireshark

Q31: Refer to the graphic. <img src="https://d2lvgg3v3hfg70.cloudfront.net/C1485/.jpg" alt="Refer