Multiple Choice
The preferred method for specifying angular dimensions is:
A) As degrees, minutes, and seconds
B) As whole degrees - fractional degrees should not be used
C) As decimal degrees
D) Determined by the individual drafter
Correct Answer:
Verified
Correct Answer:
Verified
Related Questions
Q1: T-slots and T-nuts are symmetrical, and are
Q2: An angle of 30 ° 15" could
Q3: The standard tolerance for angles applies to
Q4: T-nuts have a threaded hole and a
Q5: Which of the following does NOT describe
Q6: Dovetail accuracy is measured indirectly, by placing
Q7: Lines and surfaces shown to be at
Q9: This feature of a drill press or
Q10: Angular tolerances are always shown in the
Q11: The edges of a dovetail are "broken",